EXAMPLES: The following are examples of when the numeral "
1” is used rather than the word "one”—January 1; 1 percent; 1, 5, or 7; or $1.
. Avoid using parentheses. If certain material is important to the thought or concept expressed in the rule, the material should be set apart with commas, not parentheses. Otherwise, place the material, if necessary, in an explanatory note immediately following the rule itself.
The use of definitions is an important technique to achieve consistency and clarity of terminology within a chapter or section of rules. If a definition of a word or term applies to an entire chapter, the definition should appear at or near the beginning of the chapter. If a definition applies only to a particular rule section or subsection, it should appear only in that section or subsection, not somewhere else in the chapter or in a different chapter. Also, the extent of the applicability of the definitions should be clearly stated; for example, the definitions might be preceded by the phrase "In this chapter:” or "In this section:”. Definitions are arranged alphabetically.
A definition is always drafted as a complete sentence. Substantive provisions are never incorporated as part of a definition.
EXAMPLES OF INCORRECT STYLE:
DHS 83.04 (18) Department. The Wisconsin department of health services.
(Example of incomplete sentence.)
DHS 83.04 (18) "Department” means the Wisconsin department of health services, which shall administer this chapter.
(Example of additional substance added.)
EXAMPLE OF CORRECT STYLE:
DHS 83.04 (18) "Department” means the Wisconsin department of health services.
The use of the term "means” in a definition limits the scope of the definition solely to the example or examples stated. Use of the term "includes” expands the scope of the definition to encompass other reasonably related examples not specifically enumerated. If a rule is interpreting a statute that contains a definition using the term "includes,” the rule cannot use the term "means” in defining the same word.
If a rule uses a definition that is identical to one found in the statutes, the definition may be drafted as a simple reference to the statutory definition; for example, "`Obligation' has the meaning given in s. 150.01 (16)
. Acronyms or other abbreviations should be used only to improve readability. If acronyms are used for units of measurement, names of agencies or programs, or phrases in a rule, they must be defined and used consistently. If some purpose is served by using the full phrase interchangeably with the acronym, include both in the definition; for example, "`EIA' or `environmental impact analysis' means . . . .”
1.01(9)(9) Avoid certain words and phrases
Do not use slashed alternatives, such as "and/or,” in drafting administrative rules. Instead, determine whether the sentence means "and” or "or” and use the appropriate word. If the thought to be expressed involves a choice between one of two alternatives, or both, the proper phrasing to be used is "_________ or _________, or both.”
Avoid the use of the words "currently,” "now,” and "formerly,” since these terms are meaningless once rules are printed. If necessary, make reference to a certain date; for example, "loans entered into on or after January 1, 1991.” If an agency wishes to insert the actual effective date of a rule into the text, this may be done by incorporating, in the location where the date is to appear, the following text—"the effective date of this section . . . . [LRB inserts date].” This permits LRB to substitute the actual date.
Avoid the use of vague words and phrases, such as "thereto,” "
herein,” "thereafter,” "above,” "below,” "hereafter,” "heretofore mentioned,” and "hereunder.” Instead use specific references, such as "in this chapter,” "in subd. 1.,” or "under this section.” [See also s. 1.07 (1) (a)
, Manual.] Do not use the words "said” or "such” in place of an article; for example, "said form” should be "the form.” To avoid ambiguity, use specific references; for example, "the form specified in subd. 1.” Avoid the use of the vague term "etc.”
When referring to a series of provisions or numbers, use "to” rather than "through”; for example, use "pars. (a) to (e)” or "items 11. to 20.”
Generally use the singular form of a word. Do not use "(s)” to indicate that the word may be singular or plural.
In definitions and in substantive provisions of a rule, "including, but not limited to,” should be avoided because it has the same meaning as "including.”
Arrangement of rule-making orders.
New administrative rules are created and existing rules are revised or repealed by rule-making orders adopted by agencies with rule-making authority. A rule-making order begins with an introductory clause that is comprised of an enumeration of the rule provisions treated by the proposed order and the nature of the treatment and a
relating clause concisely stating the subject matter of the proposed order.
In the enumeration of provisions treated, group the provisions in the following order: to repeal; to renumber; to renumber and amend; to consolidate, renumber, and amend; to amend; to repeal and recreate; and to create.
If a rule will have an impact on small business, include the phrase "and affecting small business” at the end of the relating clause, so that the Rules Clearinghouse can separately identify the rule on its website. [s. 227.15 (1m)
The Wisconsin Department of Agriculture, Trade and Consumer Protection proposes an order to repeal ATCP 7.02 (1); to renumber ATCP 7.02 (2); to renumber and amend ATCP 7.03; to amend ch. ATCP 7 (title) and ATCP 7.04 (title) and (2) and 7.05 (3) (a) (Note) and (b); to repeal and recreate ATCP 7.02 (3) and 7.05 (1); and to create ATCP 7.025, relating to dairy plant trustees.
Immediately following the introductory clause is a rule summary, as described in s. 227.14 (2)
, Stats. (which refers to the summary as an "analysis”). The summary should contain all of the following headings; if there is no information under a particular heading, the heading is included and the text should state that there is no information:
Summary of, and comparison with, existing or proposed federal statutes and regulations.
Summary of factual data and analytical methodologies.
Analysis and supporting documents used to determine effect on small business or in preparation of an economic impact analysis.
A copy of any comments and opinion prepared by the Board of Veterans Affairs under s. 45.03 (2m)
, Stats., for rules proposed by the Department of Veterans Affairs.
Agency contact person (including e-mail and telephone number).
Place where comments are to be submitted and deadline for submission.
NOTE: Executive Order #50, Guidelines for Promulgation of Administrative Rules, issued by Governor Scott Walker on November 2, 2011, requires agencies to submit the draft rule summary (analysis) under s. 227.14 (2), Stats., to the Governor prior to submittal of a proposed rule to the Rules Clearinghouse.
The purpose of the plain language analysis under par. (a) 5., above, is to provide an understandable and objective description of the effect of the rule. The analysis is not intended to be an exhaustive discussion of the rule, but should contain sufficient detail to enable the reader to understand the content of the rule and the changes made, if any, in existing rules. It should be written in plain, simple English.
Since all authority for administrative rules is conferred by statute, it is important for agencies to identify the specific statutes that authorize promulgation. An agency should cite the statute that explicitly grants authority to the agency to promulgate the rule. If the agency does not have explicit authority to promulgate the rule and the agency considers the rule necessary to effectuate the purpose of a statute, the agency should cite the statute that grants general rule-making authority to the agency to enforce or administer a statute. [s. 227.11 (2) (a)
, Stats.] Also, an agency should carefully review a proposed rule for consistency with all relevant statutes.
An agency may promulgate rules interpreting the provisions of a statute enforced or administered by the agency, if the agency considers it necessary to effectuate the purpose of the statute, but a rule is not valid if it exceeds the bounds of correct interpretation. All of the following apply to the promulgation of a rule that interprets the provisions of a statute enforced or administered by the agency:
A statutory or nonstatutory provision containing a statement or declaration of legislative intent, purpose, findings, or policy does not confer rule-making authority on the agency or augment the agency's rule-making authority beyond the rule-making authority that is explicitly conferred on the agency by the Legislature.
A statutory provision describing the agency's general powers or duties does not confer rule-making authority on the agency or augment the agency's rule-making authority beyond the rule-making authority that is explicitly conferred on the agency by the Legislature.
A statute containing a specific standard, requirement, or threshold does not confer on the agency the authority to promulgate, enforce, or administer a rule that contains a standard, requirement, or threshold that is more restrictive than the standard, requirement, or threshold contained in the statute.
An agency may not implement or enforce any standard, requirement, or threshold, including as a term or condition of any license issued by the agency, unless that standard, requirement, or threshold is explicitly required or explicitly permitted by statute or by rule. [s. 227.10 (2m)
NOTE: See also Executive Order #50 regarding agency authority to promulgate rules.
1.02(3)(3) Text of rule
. In drafting a chapter or section of administrative rules, proper organization of the text of the rule is important to aid the reader in understanding the pattern of regulation or required conduct set forth in the rule. Single-section chapters should be avoided. Combine similar material into a chapter with several sections, rather than arranging each section as a separate chapter. If it enhances clarity and convenience in locating provisions, a long or complex rule may be divided into appropriate chapters. The recommended sequence of material in a rule chapter or rule section is as follows:
Purpose of the chapter or section. A purpose statement is not necessary, but if it is included, it should be the first item.
Definitions of words or terms used in the chapter or section.
Substantive provisions in their order of importance, time sequence, or other logical arrangement.
Exceptions, exemptions, or exclusions, if any, to the chapter or section.
Benefits, sanctions, or results of compliance or noncompliance with the chapter or section.
NOTE: See also s. 1.04, Manual, for the arrangement of rule text in Sections.
NOTE: When drafting proposed changes to an existing rule, the current version of a rule should be used. To obtain a copy of the current version, contact Bruce Hoesly or Tami Dodge at LRB.
1.02(3m)(3m) Initial applicability
. If there is an existing rule that is modified by a rule, an agency may wish to include an initial applicability clause after the text of the rule and before the effective date clause described in sub. (4). An initial applicability clause may be used to apply the revised rule to events occurring on or after the effective date, and to apply the existing rule to events occurring before the effective date. An initial applicability clause may also be used to provide that a new rule applies to events occurring on or after a specified date.
Section __. Initial applicability. This rule first applies to license renewal applications that are submitted on the effective date of this rule.
Each rule must have an effective date clause. If an agency intends that a rule take effect on the first day of the month following publication in the Register, the effective date clause should cite s. 227.22 (2) (intro.)
, Stats. [See also s. 2.115
Effective date. This rule shall take effect on the first day of the month following publication in the Wisconsin Administrative Register as provided in s. 227.22 (2) (intro.), Stats.
If a rule will take effect on a specified date, the effective date clause should specify that date.
If the agency desires a particular effective date for a rule, it should confirm the proposed date with LRB to be certain that the desired date is feasible.
An effective date is set forth in a numbered Section
at the end of a rule-making order. [See the example under par. (a), above.] LRB will include the effective date in the Register and in the Wisconsin Administrative Code (Administrative Code) in a history note.
1.02(5)(5) Emergency rule
. If the rule is an emergency rule, it must include a statement of the facts constituting an emergency. [See s. 2.12
1.02(6)(6) Regulatory flexibility analysis
If the rule will have any effect on small business, an initial regulatory flexibility analysis must be prepared and, if the rule may have an economic impact on small business, the rule must be submitted to the Small Business Regulatory Review Board (SBRRB). The initial regulatory flexibility analysis must be included in the notice of hearing. [ss. 227.14 (2g)
and 227.17 (3) (f)
, Stats.; and s. 2.04 (6) (d)
The SBRRB will determine whether the rule will have a significant economic impact on a substantial number of small businesses. The agency will also need to prepare a final regulatory flexibility analysis for submission to the Legislature along with the proposed rule unless the SBRRB determines that the rule will not have a significant economic impact on a substantial number of small businesses. [s. 227.19 (3) (e)
, Stats.; and s. 3.02 (2) (p)
NOTE: The term "small business” is defined in s. 227.114 (1), Stats.
A fiscal estimate is required for all proposed rules under s. 227.14 (4)
, Stats. The fiscal estimate must include all of the following:
Any anticipated fiscal effect of the rule on the fiscal liability and revenues of a county, city, village, town, school district, technical college district, and sewerage district.
A projection of the rule's anticipated state fiscal effect in the current biennium and a projection of the net annualized fiscal impact on state funds.
For rules that the agency determines may have a significant fiscal effect on the private sector, the anticipated costs that will be incurred by the private sector in complying with the rule.
A list of the major assumptions used in preparing the estimate.
If the rule has no fiscal effect, independent of the fiscal effect of the statute upon which it is based, the agency should base its fiscal estimate on the fiscal effect of the statute.
If, during the rule-making process, the rule is substantially revised so that the fiscal effect is significantly changed, the agency must prepare a revised fiscal estimate prior to promulgating the rule. The revised fiscal estimate is published in the Register.
The fiscal estimate must accompany any rule that is submitted to the Rules Clearinghouse for review under s. 227.15
The fiscal estimate or a summary of the fiscal estimate and a statement of the availability of the full fiscal estimate must be provided to LRB when a notice of hearing on the rule is filed for publication in the Register. If the agency initiates the rule-making process with a 30-day notice pursuant to s. 227.16 (2) (e)
, Stats., the full fiscal estimate must be provided to LRB for publication with the notice.