ATCP 78.21(1)(c)2.
2. There shall be a vertical separation of at least 2 1/2 feet measured from the top of the lower mattress to the bottom of the frame of the upper bed.
Pf
ATCP 78.21(1)(c)3.
3. A free space of at least 2 1/2 feet shall be provided above the mattress of the upper bed.
Pf
ATCP 78.21(1)(c)4.
4. Bunk beds shall be located away from potential hazards, including heat sources, ceiling fans, or other ceiling protrusions.
Pf
ATCP 78.21(1)(c)5.
5. When campers sleep in upper bunks, guards shall be installed to prevent occupants from rolling out and shall meet all of the following:
P
ATCP 78.21(1)(c)5.a.
a. The top of the rail shall be at least 5 inches above the top of the mattress.
Pf
ATCP 78.21(1)(c)5.b.
b. The bottom of the rail shall be no more than 3 and a half inches above the top of the bed frame.
Pf
ATCP 78.21(1)(d)
(d)
Screening. A camp shall use one of the following screening methods:
ATCP 78.21(1)(d)1.
1. 16 mesh wire or other effective screening kept in good repair shall be provided on all openings in sleeping quarters to prevent the entry of pests.
Pf
ATCP 78.21(1)(e)1.1. If provided, pillowslips, sheets, towels, and washcloths shall be washed at least once a week and before being assigned to a different camper.
ATCP 78.21(1)(e)2.
2. Blankets, spreads, mattresses, sleeping bags and pillows shall be kept clean and free of pest infestation.
ATCP 78.21(1)(e)3.a.
a. Covered with a nonabsorbent cover, pad or have an easily cleanable nonabsorbent mattress surface.
Pf
ATCP 78.21(1)(e)4.
4. The cover, pad, or other approved protection shall be cleaned before being assigned to a different camper and more often if necessary to maintain cleanliness.
ATCP 78.21(1)(e)5.
5. If provided, sleeping bags shall be washed before being assigned to a different camper.
ATCP 78.21(2)
(2)
Recreational vehicles. If a recreational vehicle is provided by the camp for overnight sleeping quarters for campers, the recreational vehicle shall meet all of the following:
ATCP 78.21(2)(a)
(a)
Identification. Be provided with an affixed label, symbol, or other identifying mark of approval by a nationally recognized testing laboratory, inspection agency, or other organization, which evaluates products to nationally recognized standards NFPA 1192 or ANSI 119.5.
ATCP 78.21 Note
Note: Examples of organizations with recognized standards include the Recreational Vehicle Industry Association and the Recreational Park Trailer Industry Association.
ATCP 78.21(2)(b)
(b)
Requirements. The chassis and axles remain on the unit with the tow bar or hitch and wheels left at the camp.
ATCP 78.21(3)
(3)
Open air sleeping experiences. Open air sleeping experiences include sleeping in collapsible tents or tents covering a non-collapsible framework that remains in a single location for less than 29 consecutive days, sleeping outdoors without any structure, in hammocks, under a pavilion, or sleeping in Adirondack shelters.
ATCP 78.21(3)(a)
(a)
Capacity. The capacity for campers in a tent shall not exceed the manufacturer's specification for maximum occupancy.
ATCP 78.21(3)(b)
(b)
Screening or netting. Screening or netting may be provided to a camper upon request.
ATCP 78.21 Note
Note: Using a cave for overnight sleeping when bats are present October 1-May 15 is not recommended and may be prohibited if federally threatened or endangered bat species are present. Campers entering caves are subject to compliance with the Wisconsin department of natural resources-approved White-Nose Syndrome decontamination protocols required by s.
NR 40.07 (8) (c).
ATCP 78.21 History
History: CR 21-109: cr.
Register June 2023 No. 810, eff. 9-24-23; correction in (1) (c) 2., 3., (3) (intro.) made under s.
35.17, Stats., and correction in (3) (c) made under s.
13.92 (4) (b) 4., Stats.,
Register June 2023 No. 810.
ATCP 78.22(1)(a)(a) Container design. Garbage and refuse shall be kept in durable, easily cleanable, pest resistant, leak-proof and nonabsorbent containers. Plastic bags may be used to line these containers.
ATCP 78.22(1)(b)1.1. Containers used in food preparation and utensil washing areas for holding garbage and refuse shall be kept covered or closed when not in use.
ATCP 78.22(1)(b)2.
2. Containers for holding garbage and refuse shall be emptied at a frequency that minimizes the
development
of
objectionable
odors
and
other
conditions
that attract or harbor pests.
ATCP 78.22(1)(c)1.1. Containers stored outside as well as dumpsters, compactors and compactor systems shall meet all of the following:
ATCP 78.22(1)(c)2.
2. Containers designed with drains shall have the drain plugs in place at all times, except during cleaning.
ATCP 78.22(1)(d)
(d)
Capacity. A
camp
shall
have
a
sufficient
number
of
containers
to
hold its garbage and refuse until
disposal.
ATCP 78.22(1)(e)1.1. Soiled containers shall be cleaned at a frequency sufficient to
prevent pest attraction.
ATCP 78.22(1)(e)2.
2. Each container shall be thoroughly cleaned on
the
inside
and
outside
in
a
way
that
does
not
contaminate food, equipment, utensils or food preparation areas.
ATCP 78.22(2)(a)1.1. Garbage and refuse stored inside shall be stored in a manner to make the garbage and refuse inaccessible to pests.
ATCP 78.22(2)(a)2.
2. Outside storage of unprotected plastic bags or wet-strength paper
bags
or
baled
units
containing
garbage
or
refuse
is prohibited.
ATCP 78.22(2)(a)3.
3. Cardboard or other packaging material not containing garbage or
food
wastes
need
not
be
stored
in
covered
containers.
ATCP 78.22(2)(b)
(b)
Storage room design. Garbage or refuse storage rooms, if used, shall be constructed of
easily
cleanable,
nonabsorbent
materials,
shall
be
kept clean, shall be pest-proof and shall be large enough to
store
all the
garbage
and
refuse
containers.
ATCP 78.22(2)(c)
(c)
Outdoor storage capacity. Outdoor storage areas or enclosures shall meet all of the following:
ATCP 78.22(2)(d)
(d)
Recyclable and
returnable items. Shall
be
stored
in
a
clean
and sanitary manner to prevent pest attraction.
ATCP 78.22(3)(a)(a)
Frequency. Garbage and refuse shall be disposed of often enough to prevent odor and attracting pests.
ATCP 78.22(3)(b)
(b)
Wisconsin department of natural resources compliance. Solid waste disposal, including composting, on the premises shall comply with chs.
NR 500 to
538, as enforced by the Wisconsin department of natural resources.
ATCP 78.22 History
History: CR 21-109: cr.
Register June 2023 No. 810, eff. 9-24-23.
ATCP 78.23
ATCP 78.23
Food preparation and service. ATCP 78.23(1)(1)
Standards. The preparation and service of food and the equipment used for that purpose at camp dining halls, commissary operations, concession stands and outdoor food service operations shall comply with ch.
ATCP 75
Appendix.
ATCP 78.23(2)
(2)
Knowledge of food protection practices. The
operator
or
at
least
one
manager of
the
food
service
facility
at
each
camp
shall
have
a certified food protection manager in compliance with the requirements of chapter 12 of the ch.
ATCP 75 Appendix.
ATCP 78.23(3)
(3)
Use of food facilities. When a rental group uses a
camp's food service facilities and the camp operator does not provide staffing, the operator, in consultation with the person certified pursuant to
sub.
(2),
shall
provide
the
group
with
written
or
video-presented
procedures to be followed
for
the
safe
handling
of
food,
personal
hygiene, and proper washing and sanitizing of utensils and equipment.
ATCP 78.23(4)
(4)
Outdoor food service. Outdoor food service at camps shall meet all of the following requirements:
ATCP 78.23(4)(c)
(c) Restrict campers from using campfires, camp stoves, or flammable liquids until campers are provided with adequate instruction on their proper use and care and supervised until competency is demonstrated.
Pf
ATCP 78.23 History
History: CR 21-109: cr.
Register June 2023 No. 810, eff. 9-24-23; (4) (a) title repealed under s. 13.92 (4) (b) 2., Stats., and correction in numbering of (4) (a) to (c) under s. 13.92 (4) (b) 1., Stats.,
Register June 2023 No. 810.
ATCP 78.24(1)(1)
Wisconsin building code. Except as specified in this section, all
buildings
at
a camp shall comply with applicable Wisconsin department of safety and professional services standards as enforced by the Wisconsin department of safety and professional services.
ATCP 78.24(2)
(2)
Handrails, guards and stairs. Except as provided in par.
(d), handrails and guards shall be provided as follows:
ATCP 78.24(2)(a)
(a)
Handrails. A flight of stairs with more than 3 risers shall be provided with at least one handrail with a height of 30 to 38 inches above the step for the full length of the flight.
Pf
ATCP 78.24(2)(b)1.a.a. Guards shall be provided on all open sides of stairs consisting of more than 3 risers,
Pf and
ATCP 78.24(2)(b)1.b.
b. All elevated surfaces in interior and exterior structures shall be provided with guards on all open sides that are elevated more than 24 inches above the floor or grade,
Pf including lofts, open sides of landings, platforms, decks, balconies or porches.
ATCP 78.24(2)(b)2.
2. The guard height shall extend to at least 36 inches above the floor or to the underside of a stair handrail.
Pf
ATCP 78.24(2)(b)3.
3. Except as specified in subd.
4., a guard shall not have openings that allow passage of a sphere not less than 4 3/8 inches in diameter.
Pf
ATCP 78.24(2)(b)4.
4. A rope, cable, or similar material used in guard infill shall not have openings that allow passage of a sphere 3 and a half inches in diameter with vertical supports a maximum of 4 feet apart.
Pf
ATCP 78.24(2)(c)1.1. The triangular openings at the open sides of a stair, formed by the riser, tread and bottom rail shall not have openings that allow passage of a sphere 6 inches in diameter.
ATCP 78.24(2)(c)2.
2. Stairs with open risers shall not exceed more than 4 inches in height.
ATCP 78.24(2)(d)
(d)
Exemptions. This section, does not apply to window wells, egress wells, retaining walls, other landscaping features or detached walkways or stairs that are not part of the building structure.
ATCP 78.24(3)(a)1.1. Doors must be arranged to be opened from the occupant's side whenever the building is occupied.
ATCP 78.24(3)(a)2.
2. A latch or other fastening device on a door must be provided with a knob, panic bar, or other simple type of releasing device having a method of operation that is obvious under all lighting conditions.
ATCP 78.24(3)(b)
(b)
Exit signage. All exits and access ways in a public building or place of employment must be marked by an approved sign visible from any direction of exit access as enforced by the Wisconsin department of safety and professional services.
