Register February 2006 No. 602
Chapter NR 464
NATIONAL EMISSION STANDARDS FOR HAZARDOUS AIR POLLUTANTS
FROM THE PULP AND PAPER INDUSTRY
NR 464.01 Applicability; purpose.
NR 464.03 Standards for the pulping system at kraft, soda and semi-chemical processes.
NR 464.04 Standards for the pulping system at sulfite processes.
NR 464.05 Standards for the bleaching system.
NR 464.06 Standards for kraft pulping process condensates.
NR 464.07 Clean condensate alternative.
NR 464.08 Standards for enclosures and closed-vent systems.
NR 464.09 Monitoring requirements.
NR 464.10 Recordkeeping requirements.
NR 464.11 Reporting requirements.
NR 464.01(1)(a)(a) The provisions of this chapter apply to the owner or operator of processes that produce pulp, paper or paperboard; that are located at a plant site that is a major source as defined in
s. NR 460.02 (24) and that use the any of following processes and materials:
NR 464.01(1)(a)1.
1. Kraft, soda, sulfite or semi-chemical pulping processes using wood.
NR 464.01(1)(b)
(b) The affected source to which the existing source provisions of this chapter apply is as follows:
NR 464.01(1)(b)1.
1. For the processes specified in
par. (a) 1., the affected source is the total of all HAP emission points in the pulping and bleaching systems.
NR 464.01(1)(b)2.
2. For the processes specified in
par. (a) 2. or
3., the affected source is the total of all HAP emission points in the bleaching system.
NR 464.01(1)(c)
(c) The new source provisions of this chapter apply to the total of all HAP emission points at new or existing sources as follows:
NR 464.01(1)(c)1.
1. Each affected source defined in
par. (b) 1. that commences construction or reconstruction after December 17, 1993.
NR 464.01(1)(c)2.
2. Each pulping system or bleaching system for the processes specified in
par. (a) 1. that commences construction or reconstruction after December 17, 1993.
NR 464.01(1)(c)3.
3. Each additional pulping or bleaching line at the processes specified in
par. (a) 1. that commences construction after December 17, 1993.
NR 464.01(1)(c)4.
4. Each affected source defined in
par. (b) 2. that commences construction or reconstruction after March 8, 1996.
NR 464.01(1)(c)5.
5. Each additional bleaching line at the processes specified in
par. (a) 2. or
3. that commences construction after March 8, 1996.
NR 464.01(1)(d)
(d) Each existing source shall achieve compliance no later than April 16, 2001, except as provided in
par. (e) and
subds. 1. and
2.:
NR 464.01(1)(d)1.
1. Each kraft pulping system shall achieve compliance with the pulping system provisions of
s. NR 464.03 for the equipment listed in
s. NR 464.03 (1) (a) 2. to
5. as expeditiously as practicable, but in no event later than April 17, 2006, and the owners and operators shall establish dates, update dates and report the dates for the milestones specified in
s. NR 464.11 (2).
NR 464.01(1)(d)2.
2. Each dissolving-grade bleaching system at either kraft or sulfite pulping mills shall achieve compliance with the bleach plant provisions of
s. NR 464.05 as expeditiously as practicable, but in no event later than 3 years after the promulgation of the revised effluent limitation guidelines and standards under
40 CFR 430.14 to
430.17 and
430.44 to
430.47.
NR 464.01(1)(e)
(e) Each bleaching system complying with the voluntary advanced technology incentives program for effluent limitation guidelines in
40 CFR 430.24 shall, for the effluent limitation guidelines and standards in
40 CFR 430.24, comply with the bleach plant provisions of
40 CFR 63.445 as expeditiously as practicable, but in no event later than April 16, 2001, or shall comply with all of the following:
NR 464.01(1)(e)1.
1. The owner or operator of a bleaching system shall comply with the bleach plant provisions of
s. NR 464.05 as expeditiously as practicable, but in no event later than April 15, 2004.
NR 464.01(1)(e)2.
2. The owner or operator of a bleaching system shall comply with the requirements specified in either of the following:
NR 464.01(1)(e)2.a.
a. Not increase the application rate of chlorine or hypochlorite, in kg of bleaching agent per megagram of ODP, in the bleaching system above the average daily rates used over the 3 months prior June 15, 1998, until the requirements of
subd. 1. are met, and record application rates as specified in
s. NR 464.10 (3).
NR 464.01(1)(e)2.b.
b. Comply with enforceable effluent limitations guidelines for 2,3,7,8-tetrachloro-dibenzo-p-dioxin and adsorbable organic halides at least as stringent as the baseline best available technology economically achievable levels set in
40 CFR 430.24(a) (1) as expeditiously as possible, but in no event later than April 16, 2001.
NR 464.01(1)(f)
(f) Each new source, specified as the total of all HAP emission points for the sources specified in
par. (c), shall achieve compliance upon startup or by June 15, 1998, whichever is later, as provided in
s. NR 460.05 (2).
NR 464.01(1)(g)
(g) Each owner or operator of an affected source with affected process equipment shared by more than one type of pulping process shall comply with the applicable requirement in this chapter that achieves the maximum degree of reduction in HAP emissions.
NR 464.01(1)(h)
(h) Each owner or operator of an affected source specified in
pars. (a) to
(c) shall comply with the requirements of
ch. NR 460, according to the applicability of
ch. NR 460 to the sources, as indicated in Appendix S of
ch. NR 460.
NR 464.01(1)(i)
(i) All references to
40 CFR part 63 and
40 CFR part 430 in this chapter mean those parts of the code of federal regulations as in effect on April 1, 2002, except that in the case of CFR provisions incorporated by reference in
ch. NR 484, if a more recent date is specified in the applicable section of
ch. NR 484, that date shall apply.
NR 464.01 Note
Note: Compliance dates are federally enforceable under
40 CFR 63.440 prior to the effective date of this section.
NR 464.01(2)
(2) Purpose. This chapter is adopted under ss.
285.27 (2) and
285.65, Stats., to establish emission standards for hazardous air pollutants from the pulp and paper industry.
NR 464.01 Note
Note: This chapter is based on the federal regulations contained in
40 CFR part 63 subpart S, created April 15, 1998, as last revised on December 22, 2000.
NR 464.01 History
History: CR 00-175: cr.
Register March 2002 No. 555, eff. 4-1-02.
NR 464.02
NR 464.02 Definitions. For terms not defined in this section, the definitions contained in
chs. NR 400 and
460 apply to the terms used in this chapter, with definitions in
ch. NR 460 taking priority over definitions in
ch. NR 400. In addition, the definitions in this section apply to the terms used in this chapter. If this section defines a term which is also defined in
ch. NR 400 or
460, the definition in this section applies in this chapter. In this chapter:
NR 464.02(1)
(1) “Acid condensate storage tank" means any storage tank containing cooking acid following the sulfur dioxide gas fortification process.
NR 464.02(2)
(2) “Black liquor" means spent cooking liquor that has been separated from the pulp produced by the kraft, soda or semi-chemical pulping process.
NR 464.02(3)
(3) “Bleaching" means brightening of pulp by the addition of oxidizing chemicals or reducing chemicals.
NR 464.02(4)
(4) “Bleaching line" means a group of bleaching stages arranged in series such that bleaching of the pulp progresses as the pulp moves from one stage to the next.
NR 464.02(5)
(5) “Bleaching stage" means all process equipment associated with a discrete step of chemical application and removal in the bleaching process including chemical and steam mixers, bleaching towers, washers, seal (filtrate) tanks, vacuum pumps, and any other equipment serving the same function as those previously listed.
NR 464.02(6)
(6) “Bleaching system" means all process equipment after high-density pulp storage prior to the first application of oxidizing chemicals or reducing chemicals following the pulping system, up to and including the final bleaching stage.
NR 464.02(7)
(7) “Boiler" means any enclosed combustion device that extracts useful energy in the form of steam. A boiler is not considered a thermal oxidizer.
NR 464.02(8)
(8) “Chip steamer" means a vessel used for the purpose of preheating or pretreating wood chips prior to the digester, using flash steam from the digester or live steam.
NR 464.02(9)
(9) “Closed-vent system" means a system that is not open to the atmosphere and is composed of piping, ductwork, connections and, if necessary, flow-inducing devices that transport gas or vapor from an emission point to a control device.
NR 464.02(10)
(10) “Combustion device" means an individual unit of equipment, including but not limited to, a thermal oxidizer, lime kiln, recovery furnace, process heater or boiler, used for the thermal oxidation of organic hazardous air pollutant vapors.
NR 464.02(11)
(11) “Day" means any 24 hour period corresponding to either midnight to midnight or to the actual 24 hour production day used by a specific facility.
