NR 216.27(3)(e)6.6. Material handling sites including storage, loading, unloading, transportation, or conveyance of any raw material, finished product, intermediate product and by-product or waste areas.
NR 216.27(3)(e)7.7. Storage areas for raw materials, finished and intermediate products including tank farms.
NR 216.27(3)(e)8.8. Disposal or application of wastewater.
NR 216.27(3)(e)9.9. Areas containing residual pollutants from past industrial activity.
NR 216.27(3)(e)10.10. Areas of significant soil erosion.
NR 216.27(3)(e)11.11. Refuse sites.
NR 216.27(3)(e)12.12. Vehicle maintenance and cleaning areas.
NR 216.27(3)(e)13.13. Washing areas for equipment, vehicles, containers or other material.
NR 216.27(3)(e)14.14. Shipping and receiving areas.
NR 216.27(3)(e)15.15. Manufacturing buildings.
NR 216.27(3)(e)16.16. Residual treatment, storage and disposal sites.
NR 216.27(3)(e)17.17. Any other areas capable of contaminating storm water runoff.
NR 216.27(3)(f)(f) Specific pollutants likely to be present in storm water as a result of contact with source areas identified in par. (e) shall also be listed.
NR 216.27(3)(g)(g) The SWPPP shall identify all contaminated and uncontaminated sources of non-storm water discharges to the storm sewer system and indicate which are covered by WPDES permits. The SWPPP shall contain the results of the non-storm water discharge monitoring required by s. NR 216.28. If monitoring is not feasible due to the lack of suitable access to an appropriate monitoring location, the SWPPP shall include a statement that the monitoring could not be conducted and an explanation of the reasons why.
NR 216.27(3)(h)(h) The SWPPP shall rely to the maximum extent practicable, and to the extent it is cost effective, on the use of source area control best management practices that are designed to prevent storm water from becoming contaminated at the site. Source area control best management practices that are either proposed or in place at the facility shall be indicated on the facility drainage base map. The SWPPP shall provide for the use of the following applicable source area control best management practices:
NR 216.27(3)(h)1.1. Practices to control significant soil erosion.
NR 216.27(3)(h)2.2. Good housekeeping measures, preventive maintenance measures, visual inspections, spill prevention and response measures and employee training and awareness.
NR 216.27(3)(h)3.3. Covering or enclosing salt storage piles so that neither precipitation nor storm water runoff can come into contact with the stored salt; or, for facilities that use brine and have salt storage piles on impervious curbed surfaces, a means of diverting contaminated storm water to a brine treatment system for process use.
NR 216.27(3)(h)4.4. Use of a combination of precipitation control, containment, drainage controls or diversions to control section 313 water priority chemicals potentially discharged through the action of storm water runoff, leaching or wind.
NR 216.27(3)(i)(i) The SWPPP shall maintain best management practices necessary to maintain compliance with the performance standards in s. NR 151.12 for those areas that are described in s. NR 151.12 (2).
NR 216.27(3)(j)(j) The SWPPP shall identify pollutants that are likely to contaminate storm water discharges to waters of the state following implementation of source area control best management practices. Past sampling data collected at the facility or at sufficiently similar outfalls at other facilities may be used in making this determination. At a minimum, all of the following pollutants shall be considered for their potential to contaminate storm water:
NR 216.27(3)(j)1.1. Any pollutant for which an effluent limitation is contained in any WPDES permit issued to the facility by the department.
NR 216.27(3)(j)2.2. Any pollutant contained in a categorical effluent limitation or pre-treatment standard to which the facility is subject.
NR 216.27(3)(j)3.3. Any section 313 water priority chemical for which the facility has reporting requirements and which has the potential for contaminating storm water.
NR 216.27(3)(j)4.4. Any other toxic or hazardous pollutants from present or past activity at the site that remain in contact with precipitation or storm water and which could be discharged to the waters of the state and which are not regulated by another environmental program.
NR 216.27(3)(j)5.5. Any of the following parameters that might be present in significant concentrations: oil and grease; acids or bases; total suspended solids; 5-day biological oxygen demand; chemical oxygen demand.
NR 216.27(3)(j)6.6. Any pollutant identified as contributing to the impairment if the facility discharges to an impaired water.
NR 216.27(3)(k)(k) When source area control best management practices are not feasible, not cost effective or are inadequate to control storm water pollution, or when the department determines source area control best management practices are inadequate to achieve a water quality standard, the SWPPP shall prescribe appropriate storm water treatment practices as needed to reduce the pollutants in contaminated storm water prior to discharge to waters of the state. Proposed or existing storm water treatment practices shall be shown on the facility drainage basin map. The SWPPP shall provide for the following types of storm water treatment practices:
NR 216.27(3)(k)1.1. Storm water significantly contaminated with petroleum products shall be treated for oil and grease removal by an adequately sized, designed and functioning wastewater treatment device. Coverage under an individual or general WPDES permit is required for discharges of storm water from oil/water treatment devices.