2.   Boundaries of the construction site.

3.   Drainage patterns and approximate slopes anticipated after major grading activities.

4.   Areas of soil disturbance.

5.   Location of major structural and non-structural controls identified in the erosion and sediment control plan.

6.   Location of areas where stabilization BMPs will be employed.

7.   Areas that will be vegetated following land disturbing construction activities.

8.   Areas and locations of wetland on the construction site, and locations where storm water is discharged to a surface water or wetland within one-quarter mile downstream of the construction site.

9.   Areas used for infiltration of post-construction storm water runoff.

10.   An alphanumeric or equivalent grid overlying the entire construction site map.

(e)   Each erosion and sediment control plan shall include a description of appropriate control BMPs that will be installed and maintained at the construction site to prevent pollutants from reaching waters of the state. The erosion and sediment control plan shall clearly describe the appropriate erosion and sediment control BMPs for each major land disturbing construction activity and the timing during the period of land disturbing construction activity that the erosion and sediment control BMPs will be implemented. The description of erosion and sediment control BMPs shall include, when appropriate, all of the following minimum requirements:

1.   Description of interim and permanent stabilization practices, including a BMP implementation schedule. The erosion and sediment control plan shall ensure that existing vegetation is preserved when attainable and that disturbed portions of the site are stabilized.

2.   Description of structural practices to divert flow away from exposed soils, store flows, or otherwise limit runoff and the discharge of pollutants from the site. Unless otherwise specifically approved in writing by the [administering authority], structural measures shall be installed on upland soils.

3.   Management of overland flow at all areas of the construction site, unless otherwise controlled by outfall controls.

4.   Trapping of sediment in channelized flow.

5.   Staging land disturbing construction activities to limit exposed soil areas subject to erosion.

6.   Protection of downslope drainage inlets where they occur.

7.   Minimization of tracking at all vehicle and equipment entry and exit locations of the construction site.

8.   Clean up of off-site sediment deposits.

9.   Proper disposal of building and waste material.

10.   Stabilization of drainage ways.

11.   Installation of permanent stabilization practices as soon as possible after final grading.

12.   Minimization of dust to the maximum extent practicable.

(f)   The erosion and sediment control plan shall require that velocity dissipation devices be placed at discharge locations and along the length of any outfall channel as necessary to provide a non-erosive flow from the structure to a water course so that the natural physical and biological characteristics and functions are maintained and protected.

Note to Users: The erosion and sediment plan requirements of this subsection will meet the erosion control plan requirements of s. NR 216.46, Wis. Adm. Code, when prepared in accordance with good engineering practices and the design criteria, standards, and specifications published by the Wisconsin Department of Natural Resources under subch. V of ch. NR 151, Wis. Adm. Code.

(3)   EROSION AND SEDIMENT CONTROL PLAN AMENDMENTS. The applicant shall amend the erosion and sediment control plan if any of the following occurs:

(a)   There is a change in design, construction, operation, or maintenance at the site that has the reasonable potential for the discharge of pollutants to waters of the state and that has not otherwise been addressed in the erosion and sediment control plan.

(b)   The actions required by the erosion and sediment control plan fail to reduce the impacts of pollutants carried by construction site runoff.

(c)   The [administering authority] notifies the applicant of changes needed in the erosion and sediment control plan.

S. 11*   FEE SCHEDULE.