NR 263.03(1)(b)1.
1. If the facility is a direct discharger, certification shall be made to the department.
NR 263.03(1)(b)2.
2. If the facility discharges to a POTW, certification shall be made to the control authority.
NR 263.03(2)
(2)
Monthly discharge limit. The monthly average regulatory values, listed in the tables within this chapter, shall be the basis for the monthly average discharge limits in direct discharge permits and for pretreatment standards. Compliance with the monthly discharge limits is required regardless of the number of samples analyzed and averaged.
NR 263.03(3)
(3)
Canmaking with aluminum alloy containing less than 1.0% manganese. The owner or operator of any canmaking facility subject to the provisions of the canmaking subcategory shall advise the department or control authority and the EPA Office of Water Regulations and Standards, Washington, D.C. 20460, whenever it has been decided that the plant will manufacture cans from an aluminum alloy containing less than 1.0% manganese. Notification shall be made in writing not less than 30 days in advance of the scheduled production and shall provide the chemical analysis of the alloy and the expected period of use.
NR 263.03(4)
(4)
Oil and grease analysis. Follow the approved methods listed in ch.
NR 219.
NR 263.03 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89;
CR 17-046: r. and recr. (4) Register February 2021 No. 782, eff. 6-29-21. NR 263.04(1)(1)
Any existing source subject to this chapter which discharges to waters of the state shall achieve:
NR 263.04(1)(a)
(a) The effluent limitations representing BPT by July 1, 1977; and
NR 263.04(1)(b)
(b) The effluent limitations representing BAT by July 1, 1984.
NR 263.04(2)
(2) Any new source subject to this chapter which discharges to waters of the state shall achieve NSPS at the commencement of discharge.
NR 263.04(3)
(3) Any existing source subject to the steel basis material subcategory, the galvanized basis material subcategory, or the aluminum basis material subcategory which introduces process wastewater pollutants into a POTW shall achieve PSES by December 1, 1985.
NR 263.04(4)
(4) Any existing source subject to the canmaking subcategory which introduces process wastewater pollutants into a POTW shall achieve PSES by November 17, 1986.
NR 263.04(5)
(5) Any new source subject to this chapter which introduces process wastewater pollutants into a POTW shall achieve PSNS at the commencement of discharge.
NR 263.04 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.10
NR 263.10 Applicability; description of the steel basis material subcategory. This chapter applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from coil coating of steel basis material coils.
NR 263.10 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.11
NR 263.11 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BPT effluent limitations:
-
See PDF for table 
NR 263.11 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.12
NR 263.12 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BAT effluent limitations:
-
See PDF for table NR 263.12 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.13
NR 263.13 New source performance standards. Any new source subject to this subchapter shall achieve the following NSPS:
-
See PDF for table NR 263.13 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.14
NR 263.14 Pretreatment standards for existing sources. Except as provided in ss.
NR 211.13 and
211.14, any existing source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for existing sources:
-
See PDF for table NR 263.14 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.15
NR 263.15 Pretreatment standards for new sources. Except as provided in s.
NR 211.13, any new source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for new sources:
-
See PDF for table NR 263.15 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.20
NR 263.20 Applicability; description of the galvanized basis material subcategory. This subchapter applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from coil coating of galvanized basis material coils.
NR 263.20 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.21
NR 263.21 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BPT effluent limitations:
-
See PDF for table NR 263.21 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.22
NR 263.22 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BAT effluent limitations:
-
See PDF for table NR 263.22 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.23
NR 263.23 New source performance standards. Any new source subject to this subchapter shall achieve the following NSPS:
-
See PDF for table NR 263.23 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.24
NR 263.24 Pretreatment standards for existing sources. Except as provided in ss.
NR 211.13 and
211.14, any existing source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for existing sources:
-
See PDF for table NR 263.24 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.25
NR 263.25 Pretreatment standards for new sources. Except as provided in s.
NR 211.13, any new source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for new sources:
-
See PDF for table NR 263.25 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.30
NR 263.30 Applicability; description of the aluminum basis material subcategory. This subchapter applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from coil coating of aluminum basis material coils.
NR 263.30 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.31
NR 263.31 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BPT effluent limitations:
-
See PDF for table NR 263.31 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.32
NR 263.32 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BAT effluent limitations:
-
See PDF for table NR 263.32 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.33
NR 263.33 New source performance standards. Any new source subject to this subchapter shall achieve the following NSPS:
-
See PDF for table NR 263.33 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.34
NR 263.34 Pretreatment standards for existing sources. Except as provided in ss.
NR 211.13 and
211.14, any existing source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for existing sources:
-
See PDF for table NR 263.34 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.35
NR 263.35 Pretreatment standards for new sources. Except as provided in s.
NR 211.13, any new source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for new sources:
-
See PDF for table NR 263.35 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.40
NR 263.40 Applicability; description of the canmaking subcategory. This subchapter applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from canmaking processes.
NR 263.40 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.41
NR 263.41 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BPT effluent limitations:
-
See PDF for table NR 263.41 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.42
NR 263.42 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the following BAT [effluent] limitations:
-
See PDF for table NR 263.42 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.43
NR 263.43 New source performance standards. Any new source subject to this subchapter shall achieve the following NSPS:
-
See PDF for table NR 263.43 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.44
NR 263.44 Pretreatment standards for existing sources. Except as provided in ss.
NR 211.13 and
211.14, any existing source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for existing sources:
-
See PDF for table NR 263.44 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.45
NR 263.45 Pretreatment standards for new sources. Except as provided [in] s.
NR 211.13, any new source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch.
NR 211 and may not exceed the following pretreatment standards for new sources:
-
See PDF for table NR 263.45 History
History: Cr.
Register, April, 1989, No. 400, eff. 5-1-89.
NR 263.45 Note
Note: The citations of the Wisconsin administrative code correspond to provisions of the code of federal regulations as cross-referenced in the following table:
-
See PDF for table
