2. In measuring the compactness of a district by means of electronic data 10
processing, the difference between the x-coordinates of the easternmost and the 11
westernmost geographic unit centers included in the district shall be compared to the 12
difference between the y-coordinates of the northernmost and southernmost 13
geographic unit centers included in the district.
3. To determine the length and width of a district by manual measurement, the 15
distance from the northernmost point or portion of the boundary of a district to the 16
southernmost point or portion of the boundary of the same district and the distance 17
from the westernmost point or portion of the boundary of the district to the 18
easternmost point or portion of the boundary of the same district shall each be 19
measured. If the northernmost or southernmost portion of the boundary, or each of 20
these points, is a part of the boundary running due east and west, the line used to 21
make the measurement required by this subdivision shall be drawn either due north 22
and south or as nearly so as the configuration of the district permits. If the 23
easternmost or westernmost portion of the boundary, or each of these points, is a part 24
of the boundary running due north and south, a similar procedure shall be followed. 25
The lines to be measured for the purpose of this subdivision shall each be drawn as
required by this subdivision, even if some part of either or both lines lies outside the 2
boundaries of the district which is being tested for compactness.
4. The absolute values computed for individual districts under this paragraph 4
may be cumulated for all districts in a plan in order to compare the overall 5
compactness of 2 or more alternative redistricting plans for the state or for a portion 6
of the state. However, it is not valid to cumulate or compare absolute values 7
computed using the measurements under subd. 2. with those computed using the 8
measurements under subd. 3.
(d) 1. The compactness of a district is greatest when the ratio of the dispersion 10
of population about the population center of the district to the dispersion of 11
population about the geographic center of the district is one to one.
2. The population dispersion about the population center of a district or about 13
the geographic center of a district is computed as the sum of the products of the 14
population of each population data unit included in the district multiplied by the 15
square of the distance from the geographic unit center of that population data unit 16
to the population center or the geographic center of the district, as the case may be. 17
The geographic center of the district is defined by averaging the locations of all 18
geographic unit centers which are included in the district. The population center of 19
the district is defined by computing the population–weighted average of the 20
x-coordinates and y-coordinates of each geographic unit center assigned to the 21
district, it being assumed for the purpose of this calculation that each population 22
data unit possesses uniform density of population.
3. The ratios computed for individual districts under this paragraph may be 24
averaged for all districts in a plan in order to compare the overall compactness of 2 25
or more alternative redistricting plans for the state or for a portion of the state.
In preparing any redistricting plan, the legislative reference bureau shall 2
be strictly nonpartisan. No district may be drawn for the purpose of favoring a 3
political party, incumbent legislator or member of Congress, or other person or group 4
or, except to the extent required under sub. (1), for the purpose of augmenting or 5
diluting the voting strength of a language or racial minority group. In establishing 6
districts, no use shall be made of any of the following data:
(a) The residence addresses of incumbent legislators or members of Congress.
(b) Political affiliations of registered voters.
(c) Previous election results.
(d) Demographic information except as necessary to meet the requirements of 11
The number of assembly districts in any redistricting plan may not be less 13
than 54 nor more than 100. The number of senate districts in any redistricting plan 14
may not be more than one-third nor less than one-fourth of the number of assembly 15
districts. Each senate district shall contain only whole assembly districts. Except 16
as otherwise provided in this subsection, to the extent possible, each congressional 17
district shall contain only whole senate districts. The other standards specified in 18
this section shall take precedence where a conflict arises between those standards 19
and the requirement of including only whole senate districts within a congressional 20
214.008 Required provisions in redistricting bills.
Each bill delivered under 22
s. 4.006 shall provide all of the following:
That, wherever territory is described in the bill by geographic boundaries, 24
the following conventions are used:
(a) Each bound continues to the intersection with the bound next named, or to 2
the intersection with a straight-line extension of such bound.
(b) If the bound is a street, it follows the center line of the street or the center 4
line of the street extended.
(c) If the bound is a railroad right-of-way, it follows the center line of the 6
(d) If the bound is a river or stream, it follows the center of the main channel 8
of such river or stream.
(e) If the bound follows a municipal boundary, it coincides with such boundary.
That the bill first applies, with respect to regular elections, to offices filled 11
at the next occurring general election after the bill takes effect and, with respect to 12
special or recall elections, to offices filled or contested on or after the date of that 13
144.0085 Challenge based on population inequality; burden of proof.
an action is brought challenging a legislative redistricting plan under this 16
subchapter on the basis of an excessive population variance among senate or 17
assembly districts established in the plan, the legislature has the burden of 18
justifying any variance in excess of 10 percent between the population of a senate or 19
assembly district and the applicable ideal district population. If an action is brought 20
challenging a congressional redistricting plan under this subchapter on the basis of 21
an excessive population variance among congressional districts established in the 22
plan, the legislature has the burden of justifying any variance in excess of 1 percent 23
between the population of a congressional district and the applicable ideal district 24
5.15 (4) (a) of the statutes is amended to read:
(a) Except as provided in par. (c), the division ordinance or resolution 2
shall number all wards in the municipality with unique whole numbers in 3
consecutive order, beginning with the number one, shall designate the polling place 4
for each ward, and shall describe the boundaries of each ward consistent with the 5
conventions set forth in s. 4.003 4.008 (1)
. The ordinance or resolution shall be 6
accompanied by a list of the block numbers used by the U.S. bureau of the census that 7
are wholly or partly contained within each ward, with any block numbers partly 8
contained within a ward identified, and a map of the municipality which illustrates 9
the revised ward boundaries. If the legislature, in an act redistricting legislative 10
districts under article IV, section 3, of the constitution, or in redistricting 11
congressional districts, establishes a district boundary within a municipality that 12
does not coincide with the boundary of a ward established under the ordinance or 13
resolution of the municipality, the municipal governing body shall, no later than 14
April 10 of the 2nd year following the year of the federal decennial census on which 15
the act is based, amend the ordinance or resolution to the extent required to effect 16
the act. The amended ordinance or resolution shall designate the polling place for 17
any ward that is created to effect the legislative act. Nothing in this paragraph shall 18
be construed to compel a county or city to alter or redraw supervisory or aldermanic 19
13.49 of the statutes is created to read:
2113.49 Redistricting advisory commission. (1) Definitions.
In this section:
(a) "Chief election officer" means the chief election officer of the government 23
(b) "Four selecting authorities" means all of the following:
1. The majority leader of the senate.
2. The minority leader of the senate.
3. The speaker of the assembly.
4. The minority leader of the assembly.
(c) "Partisan public office" means any of the following:
1. The office of governor, lieutenant governor, secretary of state, state treasurer, 6
attorney general, state senator, or state representative to the assembly.
2. A county office which is filled by an election process involving nomination 8
and election of candidates on a partisan basis.
(d) "Political party office" means an elective office in a political party, as defined 10
in s. 5.02 (13), or in a national political party.
(e) "Relative" means an individual who is related to the person in question as 12
father, mother, son, daughter, brother, sister, uncle, aunt, first cousin, nephew, niece, 13
husband, wife, grandfather, grandmother, father-in-law, mother-in-law, 14
son-in-law, daughter-in-law, brother-in-law, sister-in-law, stepfather, 15
stepmother, stepson, stepdaughter, stepbrother, stepsister, half brother, or half 16
17(2) General provisions.
(a) Not later than February 15 of the first year 18
following the decennial federal census, a temporary redistricting advisory 19
commission is created consisting of 5 members. Each of the 4 selecting authorities 20
shall certify to the chief election officer the selecting authority's appointment of a 21
person to serve on the commission. Within 30 days after the last selecting authority 22
has certified his or her appointment, but not later than February 15 of the first year 23
following the decennial federal census, the 4 commission members so appointed shall 24
select, by a vote of at least 3 members, and certify to the chief election officer the 5th 25
commission member, who shall serve as chairperson.
(b) No individual may be appointed to the redistricting advisory commission 2
who satisfies any of the following:
1. The individual is not an eligible elector of this state at the time of the 4
2. The individual holds partisan public office or political party office.
3. The individual is a relative of or is employed by a member of the legislature 7
or of Congress, or is employed directly by the legislature or Congress.
(c) Members of the redistricting advisory commission appointed by a selecting 9
authority shall be reimbursed from the appropriation account under s. 20.765 (1) (a) 10
or (b), depending upon the house in which that member's appointing authority holds 11
office, for actual and necessary expenses incurred in performance of duties as a 12
commission member. The member who is not appointed by a selecting authority 13
shall be reimbursed from the appropriation under s. 20.765 (1) (a) for actual and 14
necessary expenses incurred in performance of duties as a commission member.
(d) A vacancy on the redistricting advisory commission shall be filled as 16
provided in s. 17.20 (1) within 15 days after the vacancy occurs.
(e) Each redistricting advisory commission terminates upon complying with 18
. The redistricting advisory commission shall do all of the following:
(a) If requested to do so by the legislative reference bureau, provide direction 21
to the legislative reference bureau concerning any decision the legislative reference 22
bureau must make in preparing a redistricting plan under subch. I of ch. 4 for which 23
no clearly applicable guideline is provided under s. 4.007.
(b) Upon delivery by the legislative reference bureau of a bill embodying a 2
redistricting plan as required under s. 4.006, make available to the public at the 3
earliest feasible time all of the following information:
1. Copies of the bill.
2. Maps illustrating the plan.
3. A summary of the standards prescribed under s. 4.007 for development of the 7
4. A statement of the population of each district included in the plan, and the 9
relative deviation of each district population from the ideal district population.
(c) Upon delivery by the legislative reference bureau of an initial bill embodying 11
a redistricting plan as required under s. 4.006 (1), do all of the following:
1. As expeditiously as reasonably possible, schedule and conduct at least 3 13
public hearings, in different geographic regions of the state, on the plan embodied 14
in the bill. No more than one public hearing may be held in the city of Madison and 15
at least one public hearing shall be held in the northern half of the state.
2. Following the hearings held under subd. 1., promptly prepare and submit 17
to the legislature in the manner provided under s. 13.172 (2) a report summarizing 18
information and testimony received by the commission in the course of the hearings. 19
The report may include any comments and conclusions which the commission's 20
members deem appropriate concerning the information and testimony received at 21
the hearings or otherwise presented to the commission. The report shall be treated 22
in the same manner as a report submitted under s. 13.172 (2).
The redistricting advisory commission may establish 24
policies limiting the information that the legislative reference bureau may provide 25
to persons outside of the bureau staff concerning any redistricting plan prepared
under subch. I of ch. 4, except that any such policy does not apply to a redistricting 2
plan after a bill embodying that plan is delivered by the legislative reference bureau 3
as required under s. 4.006 or to population data furnished to the legislative reference 4
bureau by the U.S. bureau of the census.
(1) This act first applies to redistricting plans based on the 2020 decennial 7