Register July 2015 No. 715
Chapter NR 130
NONFERROUS METALLIC MINERAL EXPLORATION
NR 130.01   Purpose.
NR 130.02   Applicability.
NR 130.03   Definitions.
NR 130.05   Application for an exploration license.
NR 130.06   Issuance.
NR 130.07   Renewals.
NR 130.08   License revocation or suspension.
NR 130.09   Denials.
NR 130.10   Notice procedure.
NR 130.11   Reports.
NR 130.12   Inspections.
Ch. NR 130 Note Note: See ss. 23.09, 23.11, chs. 107, 227, 280 and 293, Stats.
Ch. NR 130 Note Note: Emerg. r. and recr. eff. 6-3-78. Chapter NR 130 as it existed on January 31, 1979 was repealed and a new chapter NR 130 created effective February 1, 1979.
NR 130.01 NR 130.01Purpose. The purpose of this chapter is to establish a licensing procedure and minimum standards for nonferrous metallic mineral exploration in this state.
NR 130.01 History History: Cr. Register, January, 1979, No. 277, eff. 2-1-79; CR 13-057: am. Register July 2015 No. 715, eff. 8-1-15.
NR 130.02 NR 130.02Applicability. The provisions of this chapter are applicable to all nonferrous metallic mineral exploration as defined in s. NR 130.03. This chapter does not apply to operators engaged in exploration on lands included in a mining and reclamation plan, if the plan contains provisions relating to termination of the exploration activities. This chapter also does not apply to ferrous metallic mining regulated under subch. III of ch. 295, Stats.
NR 130.02 History History: Cr. Register, January, 1979, No. 277, eff. 2-1-79; CR 13-057: am. Register July 2015 No. 715, eff. 8-1-15.
NR 130.03 NR 130.03Definitions. The following definitions are applicable to the terms used in this chapter:
NR 130.03(1) (1) “Abandonment" means filling or sealing a drillhole in accordance with the procedures specified in s. NR 130.06.
NR 130.03(2) (2) “Clay slurry" means a fluid mixture of native clay formation or commercial clay or clay mineral products and water prepared with only the amount of water necessary to produce fluidity.
NR 130.03(3) (3) “Concrete grout" means a mixture consisting of 94 pounds of type A portland cement and an equal or lesser volume of dry sand combined with approximately 6 gallons of water.
NR 130.03(4) (4) “Department" means department of natural resources.
NR 130.03(5) (5) “Driller" means a person who performs core, rotary, percussion or other drilling involved in exploration for metallic minerals.
NR 130.03(6) (6) “Drilling site" means the area disturbed by exploration including the drillhole.
NR 130.03(7) (7) “Explorer" means any person who engages in exploration or who contracts for the services of drillers for the purpose of exploration.
NR 130.03(8) (8) “Exploration" means the onsite geologic examination from the surface of an area by core, rotary, percussion, or other drilling, where the diameter of the hole does not exceed 18 inches, for the purpose of searching for nonferrous metallic minerals or establishing the nature of a known nonferrous metallic mineral deposit and includes associated activities such as clearing and preparing sites or constructing roads for drilling. For the purposes of the definition of exploration, geologic examination does not include drillholes constructed for the purpose of collecting soil samples or for determining radioactivity by means of placement of radiation-sensitive devices.
NR 130.03(9) (9) “Exploration license" means the license required by s. 293.21 (2), Stats., as a condition of engaging in exploration.
NR 130.03(10) (10) “License year" means the period of time commencing on July 1 of any year and ending on the following June 30.
NR 130.03(12) (12) “Neat cement grout" means a mixture consisting of 94 pounds of type A portland cement and approximately 6 gallons of water.
NR 130.03(12m) (12m) “Nonferrous metallic mineral" has the meaning given in s. 293.01 (12m), Stats.
NR 130.03 Note Note: This definition does not apply to substances mined primarily for their iron oxide content. This definition includes substances mined for the purpose of extracting a metal or metals such as copper, zinc, lead, gold, silver, titanium, vanadium, nickel, cadmium, molybdenum, chromium, manganese, cobalt, zirconium, beryllium, thorium, and uranium.
NR 130.03(13) (13) “Parcel" means an identified section, fractional section or government lot.
NR 130.03(14) (14) “Termination" means filling of drillholes and reclamation and revegetation of drilling sites.
NR 130.03 History History: Cr. Register, January, 1979, No. 277, eff. 2-1-79; renum. (2) to (10) to be (4) to (9), (11), (13) and (14) and am. (7), cr. (intro.), (2), (3), (10) and (12), Register, March, 1985, No. 351, eff. 4-1-85; correction in (9) made under s. 13.92 (4) (b) 7., Stats., Register March 2011 No. 663; CR 13-057: am. (8), renum. (11) to (12m) and am. Register July 2015 No. 715, eff. 8-1-15.
NR 130.05 NR 130.05Application for an exploration license.
NR 130.05(1)(1) No explorer may engage in exploration without securing an exploration license.
NR 130.05(2) (2) Any explorer wishing to engage in exploration shall file an application for an exploration license with the department upon forms prepared and furnished by the department. The application shall be accompanied by the following:
NR 130.05(2)(a) (a) A fee of $300 for the exploration license.
NR 130.05(2)(b) (b) A bond payable to the department in the amount of $5,000 conditioned on faithful performance of the provisions of this code.
NR 130.05(2)(b)1. 1. The bond shall be issued by a surety company licensed to do business in Wisconsin. If the surety company's license to do business is revoked or suspended, the explorer, within 30 days after receiving written notice thereof from the department, shall substitute surety underwritten by a surety company licensed to do business in Wisconsin. Upon failure of the explorer to make a substitution of surety, the department shall suspend the explorer's exploration license until substitution has been made.
NR 130.05(2)(b)2. 2. Each bond shall provide that the bond shall not be canceled by the surety, except after not less than 90 days notice to the department in writing by registered or certified mail. Not less than 30 days prior to the expiration of the 90 day notice of cancellation, the explorer shall deliver to the department a replacement bond in the absence of which all exploration shall cease.
NR 130.05(2)(b)3. 3. The department may require that the amount of the bond be increased at any time, if the department determines that the explorer's current level of activity makes it likely that the bond would be inadequate to fund the termination of all holes drilled for which the explorer is responsible.
NR 130.05(2)(b)4. 4. One year after the issuance of the last certificate of completion, and provided that the explorer is not holding an exploration license, the department shall release the bond if the department determines that the explorer has complied with provisions of this chapter.
NR 130.05(2)(c) (c) A certificate of insurance certifying that the explorer has in force a liability insurance policy issued by an insurance company authorized to do business in this state covering all exploration of the explorer in this state and affording personal injury and property damage protection in a total amount deemed adequate by the department but not less than $50,000.
NR 130.05(2)(d) (d) A copy of the applicant's most recent annual report and Form 10K as filed with the securities and exchange commission. If these are not available, the applicant shall submit a report of the applicant's current assets and liabilities or other necessary data to establish that the applicant is competent to conduct exploration in this state.
NR 130.05 History History: Cr. Register, January, 1979, No. 277, eff. 2-1-79; am. (2) (b) 4. and (c), cr. (2) (d), Register, March, 1985, No. 351, eff. 4-1-85.
NR 130.06 NR 130.06Issuance. Upon satisfactory completion of all conditions contained in this chapter, the department shall issue an exploration license to the explorer. Licenses shall be issued within 10 business days after the department receives a complete application unless the application is for an upcoming license year. If the application is for an upcoming license year, the license shall be issued either within 10 business days after the department receives a complete application or on the following July 1, whichever is later. The issuance of an exploration license is subject to the following conditions:
NR 130.06(1) (1) Nonferrous metallic mineral exploration drillholes shall be abandoned as follows:
NR 130.06(1)(a) (a) Permanent abandonment.
NR 130.06(1)(a)1.1. All drillholes 4 inches in diameter and smaller shall be filled from the bottom of the hole upward to the ground surface with concrete or neat cement grout.
NR 130.06(1)(a)2. 2. Drillholes larger than 4 inches in diameter preferably should be filled in a manner similar to that described in sub. (1). However, the following alternative methods of filling such holes are acceptable:
NR 130.06(1)(a)2.a. a. Drillholes constructed in limestone, dolomite, shale, or pre-Cambrian formations (granite, gabbro, gneiss, schist, slate, greenstone, quartzite, etc.) may be filled with gravel or crushed rock from the bottom upward to a point 20 feet below the top of the first rock formation encountered below the surface or to a depth 40 feet below the ground surface, whichever is the greater depth, and the remainder of the drillhole from the top of the gravel or crushed stone to the ground surface shall then be filled with concrete or neat cement grout. If it is physically impractical to use gravel or crushed rock, the explorer may use clay slurry as a filling material after receiving approval from the department.
NR 130.06(1)(a)2.b. b. Drillholes constructed in sandstone formation may be filled with disinfected sand or pea gravel from the bottom upward to a point 20 feet below the top of the first rock formation encountered below the surface or to a depth 40 feet below the ground surface, whichever is the greater depth, and the remainder of the drillhole from the top of the sand or pea gravel to the ground shall then be filled with concrete or neat cement grout. If it is physically impractical to use sand or pea gravel, the explorer may use clay slurry as a filling material after receiving approval from the department.
NR 130.06(1)(a)2.c. c. Drillholes constructed in glacial drift or other unconsolidated formation may be filled with clean clay slurry from the bottom upward to a point 20 feet below the ground surface, and the remainder of the drillhole must then be filled from the top of the clay slurry to the ground surface with concrete or neat cement grout.
NR 130.06(1)(a)2.d. d. Drillholes constructed in mixed rock types may be filled in accordance with subd. 2. a., b. and c. Where the alternative methods to filling the drillhole completely with concrete or neat cement grout are selected, concrete or neat cement grout plugs at least 40 feet in depth, extending at least 20 feet above and below the point of surface contact between every recognized geologic rock type shall be provided.
Loading...
Loading...
Published under s. 35.93, Stats. Updated on the first day of each month. Entire code is always current. The Register date on each page is the date the chapter was last published.