2. Laboratory or field-test measurements specified in par. (a).
3. Department material approval process as specified in ch. SPS 361 to determine the U-factor. SECTION 220.
SPS 363.5402 is created to read:SPS 363.5402 Building envelope requirements. (1) Insulation and fenestration requirements by component. Substitute 2009 IECC Table 402.1.1 for 2015 IECC Table R402.1.2 and renumber Table R402.1.2.
(2) Equivalent u-factors. Substitute 2009 IECC Table 402.1.3 for 2015 IECC Table R402.1.4 and renumber Table R402.1.4.
(3)
Air leakage. Substitute the wording from 2009 IECC sections 402.4.1, 402.4.2, 402.4.2.1, and 402.4.2.2 for IECC sections R402.4, R402.4.1, R402.4.1.1, and R402.4.1.2.(4) Air barrier and insulation inspection component table. Substitute 2009 IECC Table 402.4.2 for 2015 IECC Table R402.4.1.1.
SECTION 221.
SPS 363.5403 (3) is created to read:SPS 363.5403 (3) Protection of piping insulation in residential buildings. The requirements in IECC section R403.4.1 are not included as part of chs. SPS 361 to 366. SECTION 222.
SPS 363.5404 is created to read:SPS 363.5404 Lighting equipment. Substitute the following wording for the requirements, but not the exception, in IECC section R404.1: A minimum of 50 percent of the lamps in permanently installed lighting fixtures shall be high-efficacy lamps.
SECTION 223.
SPS 363.5502 and 363.5503 are created to read: SPS 363.5502 Additions. (1) Insulation and fenestration requirements by component. Substitute 2009 IECC Table 402.1.1 for 2015 IECC Table R402.1.2 and renumber Table R402.1.2.
(2) Equivalent u-factors. Substitute 2009 IECC Table 402.1.3 for 2015 IECC Table R402.1.4 and renumber Table R402.1.4.
(3)
Air leakage. Substitute the wording from 2009 IECC sections 402.4.1, 402.4.2, 402.4.2.1, and 402.4.2.2 for IECC sections R402.4.0, R402.4.1, R402.4.1.1, and R402.4.1.2.(4) Air barrier and insulation inspection component table. Substitute 2009 IECC Table 402.4.2 for 2015 IECC Table R402.4.1.1.
SPS 363.5503 Alterations. (1) Insulation and fenestration requirements by component. Substitute 2009 IECC Table 402.1.1 for 2015 IECC Table R402.1.2 and renumber Table R402.1.2.
(2) Equivalent u-factors. Substitute 2009 IECC Table 402.1.3 for 2015 IECC Table R402.1.4 and renumber Table R402.1.4.
(3)
Air leakage. Substitute the wording from 2009 IECC sections 402.4.1, 402.4.2, 402.4.2.1, and 402.4.2.2 for IECC sections R402.4.0, R402.4.1, R402.4.1.1, and R402.4.1.2.(4) Air barrier and insulation inspection component table. Substitute 2009 IECC Table 402.4.2 for 2015 IECC Table R402.4.1.1.
SECTION 224.
SPS 363.5600 is created to read: SPS 363.5600 Referenced standards. This is a department rule in addition to the requirements in IECC chapter 6: The following standards are incorporated by reference into chs. SPS 361 to 366: (1) ASTM C177-13, Test method for steady-state heat flux measurements and thermal transmission properties by means of the guarded-hot-plate apparatus.
(2) ASTM C335/335M-10, Test method for steady state heat transfer properties of horizontal pipe insulation.
(3) ASTM C518-15, Test method for steady-state thermal transmission properties by means of the heat flow meter apparatus.
(4) ASTM C1363-11, Test method for thermal performance of materials and envelope assemblies by means of a hot box apparatus.
SECTION 225.
SPS 364.0001 (2) and (3), SPS 364.0101, and SPS 364.0202 (1) (b) are created to read:SPS 364.0001 (2) Notwithstanding any other provision of this chapter, the department may not adopt or enforce minimum ventilation standards for indoor drive-through self-service storage facilities described in Table 364.0403 that are more restrictive than the standards under this chapter applicable to warehouses.
(3)
Notwithstanding any other provision of this chapter, the department may not adopt or enforce minimum ventilation standards for a building in which a boat that is not a motorized vehicle under s. SPS 364.0202 (1) (f) is or may be stored that are more restrictive than the standards under this chapter that would otherwise apply.SPS 364.0101 Administration. Except for IMC section 102.8, the requirements in IMC chapter 1 are not included as part of this chapter.
SPS 364.0202 (1) (b) “Enclosed parking garage” means an enclosed building where motorized vehicles are stored or parked.
SECTION 226.
SPS 364.0202 (1) (c) is renumbered SPS 364.0202 (1) (am).SECTION 227.
SPS 364.0202 (1) (d) is amended to read: SPS 364.0202 (1) (d) “Health care facility” means a hospital, nursing home, or outpatient surgical facility, or community-based residential facility.
SECTION 228.
SPS 364.0202 (1) (e), (f), and (Note) are created to read:SPS 364.0202 (1) (e) “Living area” means those areas within a dwelling unit involving living rooms, bedrooms, dens, family rooms, and recreation rooms, but not rooms used for cooking, bathing, washing, and sanitation purposes.
(f) “Motorized vehicle” means a self-propelled motor-driven vehicle that is used for moving people or products on land, water, or air. “Motorized vehicle” does not include a boat that is dry stored and not operated in the building in which it is stored.
Note: "Motorized vehicle" in this definition is intended to apply to motorized equipment transporting people and goods for pleasure, construction or commerce, rather than equipment dedicated to warehousing and yard operations, such as forklifts; or for grounds and facility maintenance, such as lawnmowers; or for amusement facilities, such as go-carts.
SECTION 229.
SPS 364.0300 (1) is amended to read:SPS 364.0300 (1) This is a department rule in addition to the requirements in IMC chapter 3: In addition to the requirements in this code chs. SPS 361 to 366, the heating and ventilation systems for health care facilities only shall conform to the applicable provisions of The Facility Guidelines Institute (FGI) FGI Guidelines for Design and Construction of Health Care Hospitals and Outpatient Facilities 2014, except as provided in sub. (2). SECTION 230.
SPS 364.0301 (1) to (3) are amended to read:(1) Scope. Substitute the following wording for the requirements in IMC section 301.1: This chapter shall govern the approval and installation of all equipment and appliances that comprise parts of the building mechanical systems regulated by this code chs. SPS 361 to 366 in accordance with subch. 1I. (2) Energy utilization. This is a department informational note to be used under IMC section 301.2 301.7.
(3) Listed and labeled. Substitute the following wording for the requirements in IMC section 301.4 301.7:
