m. For nail salons, the required exhaust shall include ventilation tables or other systems that capture the contaminants and odors. The exhaust system shall be capable of exhausting the greater of 50 cfm per station or 0.6 cfm per square foot of work area. The exhaust inlet shall be located in the work area. Manicure tables and pedicure stations not provided with factory-installed exhaust inlets shall be provided with exhaust inlets located not more than 12 inches horizontally and vertically from the point of chemical application as required by IMC 502.20.
Section 160. SPS 364.0501 (3) (intro.) and (6) are amended to read:
SPS 364.0501 (3) These are department rules in addition to the requirements in IMC section 501.2.1 s. 501.3.1.
SPS 364.0501 (6) These are department rules in addition to IMC section s. 501.3.2: The bottom of an exhaust outlet shall be located at least 12 inches vertically from the adjoining grade level and, adjacent roof, and bottom of an areaway. Additional clearance may be required so as to address local weather conditions and surrounding land contour.
Section 161. SPS 364.0505 is amended to read:
SPS 364.0505 The requirements Exception 1 in IMC section 505.4 are s. 505.3 is not included as part of chs. SPS 361 to 366. Section 162. SPS 364.0506 (2) (c) is repealed.
Section 163. SPS 364.0507 (2) is repealed.
Section 164. SPS 364.0606 (1) and (2) are amended to read:
SPS 364.0606 (1) This is a department informational note to be used under IMC section s. 606.2.1: Note: For DHS licensed healthcare facilities as specified in chs. DHS 124, 131, 132, and 134, also refer to NFPA standard 90A section 4−4.2A s. 4.2.4 for air handling units between 2,000 cfm and 15,000 cfm. (2) This is a department informational note to be used under IMC section s. 606.4: Note: For DHS licensed healthcare facilities as specified in chs. DHS 124, 131, 132, and 134, also refer to NFPA standard 90A section 4−3.2 s. 4.3.10 for smoke dampers isolating air handling units. Section 165. SPS 364.0701 is amended to read:
SPS 364.0701 Barometric dampers may not be used for combustion air as allowed by IFC section s. 304.3 and NFPA 54−2015 section 54 – 2021 s. 9.3.1.4.
Section 166. SPS 364.0802 is repealed.
Section 167. SPS 364.1500 (1m), (2m), and (Note) are repealed.
Section 168. SPS 364.1500 (3) is amended to read:
SPS 364.1500 (3) NFPA 45−2015 45-2019, Standard on Fire Protection for Laboratories Using Chemicals.
Section 169. SPS 364.1500 (4) is created to read:
SPS 364.1500 (4) ANSI/ASHRAE/ASHE Standard 170-2017, Ventilation of Health Care Facilities.
Section 170. SPS 365.0501 (4) is created to read:
SPS 365.0501 (4) Plastic venting systems associated with gas-fired appliances shall meet the requirements of UL 1738, inclusive of specific testing and marking requirements for pipe, fittings, and cement.
Section 171. SPS 365.0800 is amended to read:
SPS 365.0800 Referenced standards. This is a department rule in addition to the requirements in IFGC chapter ch. 8: The following standard is incorporated by reference into chs. SPS 361 to 366: ANSI Z223.1/NFPA 54-2015 54-2021 , National Fuel Gas Code. Section 172. SPS 365.0900 is amended to read:
SPS 365.0900 IFGC Appendices A to D E are not included as part of this chapter.
Section 173. SPS 366.0101 (4) (b) and (c) are amended to read:
SPS 366.0101 (4) (b) Repairs, alterations, additions, changes in occupancy, and relocated buildings complying with the applicable requirements of IEBC chapters 5 through 13 chs. 3, 4, 6 to 12, and 14 shall be considered in compliance with the provisions of chs. SPS 361 to 366. (c) Repairs, alterations, additions, changes in occupancy, and relocated buildings complying with IEBC chapter 14 ch. 13 shall be considered in compliance with the provisions of chs. SPS 361 to 366. Section 174. SPS 366.0303 is created to read:
SPS 366.0303 The requirements in IEBC s. 303 are not included as part of chs. SPS 361 to 366. Section 175. SPS 366.0306 is created to read:
SPS 366.0306 This is a department informational note to be used under IBEC s. 306. Note: See s. 101.132, Stats., for additional accessibility requirements. Section 176. SPS 366.0400 is renumbered to 366.0500 and amended to read:
SPS 366.0500 The requirements in IEBC chapter chs. 4 5 are not included as part of chs. SPS 361 to 366, except for the requirements in IEBC section 410 when applied by IEBC section 1401.2.5. Section 177. SPS 366.0600 is renumbered to SPS 366.0308, and SPS 366.0308 (intro.), as renumbered, is amended to read:
SPS 366.0308 These are department rules in addition to the requirements in IEBC chapter 6 s. 308 and are established under the authority of s. 101.127, Stats.:
Section 178. SPS 366.0603 is renumbered to SPS 366.0307.
Section 179. SPS 366.0605 is repealed.
Section 180. SPS 366.0606 is renumbered to SPS 366.0405 and amended to read:
SPS 366.0405 The requirements in IEBC sections 606.2 to 606.2.5 ss. 405.2 to 405.2.6 are not included as part of chs. SPS 361 to 366.
Section 181. SPS 366.0609 is renumbered to SPS 366.0408 and amended to read:
SPS 366.0408 The requirements in IEBC section 609 s. 408 are not included as part of chs. SPS 361 to 366.
Section 182. SPS 366.0701 is amended to read:
SPS 366.0701 Substitute the following wording for the requirements in IEBC section s. 701.2 but not the exception: Conformance. An existing building or portion thereof may not be altered such that the building becomes less safe than was required in its existing condition.
Section 183. SPS 366.0702 (1) and (2) are amended to read:
