NR 294.02(12) (12) Sulfation processes in which sulfamic acid is employed as the sulfating agent;
NR 294.02(13) (13) Sulfation of alcohols, alkylphenols, and alcohol ethoxylates utilizing chlorosulfonic acid as the sulfating agent;
NR 294.02(14) (14) Neutralization of sulfated and sulfonated alkylbenzenes, alcohols, and other materials to convert them to neutral salts;
NR 294.02(15) (15) Manufacture of spray dried detergents, including but not limited to, assembly and storage of raw materials, crutching, spray drying, blending (including tumble spraying of additives), and packaging where there is, with or without fast turnaround operation, as defined in s. NR 294.03,
NR 294.02(15)(a) (a) Normal operation of a spray drying tower, or
NR 294.02(15)(b) (b) Air quality restricted operation of a spray drying tower;
NR 294.02(16) (16) Manufacture of liquid detergents commencing with the blending of ingredients to and including bottling or packaging finished products involving, as defined in s. NR 294.03, either normal liquid detergent operations, or fast turnaround operations;
NR 294.02(17) (17) Manufacture of detergents by dry blending ingredients, including, but not limited to, blending and subsequent packaging;
NR 294.02(18) (18) Manufacture of drum dried detergents including, but not limited to, drying of formulations on heated drums or rollers, conversion of dried detergents to powders or flakes, and the packaging of finished products; and
NR 294.02(19) (19) Manufacture of detergent bars and cakes including, but not limited to, drying, milling, plodding, stamping, and packaging.
NR 294.02 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76.
NR 294.03 NR 294.03Definitions. The following special definitions are applicable to terms used in this chapter. Definitions of other terms and meanings of abbreviations are set forth in ch. NR 205.
NR 294.03(1) (1) “Anhydrous product” means the theoretical product that would result if all water were removed from the actual product.
NR 294.03(2) (2) “Neat soap” means the solution of completely saponified and purified soap containing 20-30% water which is ready for final formulation into a finished product.
NR 294.03(3) (3) “Surfactant” means those methylene blue active substances amenable to measurement by the method described on page 131 of “Methods for Chemical Analysis of Water and Wastes”, published 1971 by the Analytical Quality Control Laboratory of the Environmental Protection Agency. Copies of this document are available for inspection at the office of the department of natural resources, the secretary of state's office, and the office of the legislative reference bureau, and may be obtained for personal use from the Water Quality Office, U.S. EPA, 1014 Broadway, Cincinnati, Ohio, 45268.
NR 294.03(4) (4) “Sweet water” means the solution of 8-10% crude glycerine and 90-92% water that is a by-product of saponification or fat splitting.
NR 294.03(5) (5) “Normal operation” of a spray drying tower means operation utilizing formulations that present limited air quality problems from stack gases and associated need for extensive wet scrubbing, and without more than 6 turnarounds in a 30 day consecutive period, thus permitting complete recycle of waste water.
NR 294.03(6) (6) “Air quality restricted operation” of a spray drying tower means an operation utilizing formulations (e.g. those with high non-ionic content) which require a very high rate of wet scrubbing to maintain desirable quality of stack gases, and thus generate much greater quantities of waste water than can be recycled to process.
NR 294.03(7) (7) “Fast turnaround operation” of a spray drying tower means operation involving more than 6 changes of formulation in a 30 consecutive day period that are of such degree and type (e.g. high phosphate to no phosphate) as to require cleaning of the tower to maintain minimal product quality.
NR 294.03(8) (8) “Normal liquid detergent operations” means all such operations except those defined as fast turnaround operation of automated fill lines.
NR 294.03(9) (9) “Fast turnaround operation of automated fill lines” means an operation involving more than 8 changes of formulation in a 30 consecutive day period that are of such degree and type as to require thorough purging and washing of the fill line to maintain minimal product quality.
NR 294.03(10) (10) “BOD7” means the biochemical oxygen demand as determined by incubation at 20` C for a period of 7 days using an acclimated seed. Agitation employing a magnetic stirrer set at 200 to 500 rpm may be used.
NR 294.03 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76; correction made in (3) under s. 13. 92 (4) (b) 6., Stats., Register April 2013 No. 688.
NR 294.04 NR 294.04Compliance with effluent limitations and standards. Discharge of pollutants from facilities subject to the provisions of this chapter may not exceed, as appropriate:
NR 294.04(1) (1) By July 1, 1977 effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available;
NR 294.04(2) (2) By July 1, 1983 effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable;
NR 294.04(3) (3) Pretreatment standards for discharges to publicly owned treatment works;
NR 294.04(4) (4) Standards of performance for new sources.
NR 294.04 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76; r. and recr. Register, August, 1983, No. 332, eff. 9-1-83.
NR 294.06 NR 294.06Application of effluent limitations and standards.
NR 294.06(1)(1) The effluent limitations and standards set forth in this chapter shall be used in accordance with this section to establish the quantity or quality of pollutants or pollutant properties which may be discharged by a point source subject to the provisions of this chapter, except as;
NR 294.06(1)(a) (a) They may be modified in accordance with subch. IV of ch. NR 220,
NR 294.06(1)(b) (b) They may be superseded by more stringent limitations and standards necessary to achieve water quality standards or meet other legal requirements, or
NR 294.06(1)(c) (c) They may be supplemented or superseded by standards or prohibitions for toxic pollutants or by additional limitations for other pollutants required to achieve water quality.
NR 294.06(2) (2) The production basis for application of the limitations and standards set forth in this chapter shall be the daily average for a maximum month for the facility in each subcategory subject to the provisions of this chapter.
NR 294.06(3) (3) The process waste discharge limitations for a facility subject to the provisions of this chapter shall be the sum of effluent limitations determined for the production of the facility in each of the applicable process or product subcategories.
NR 294.06(4) (4) For operations in subcategories (15) and (16) which are not fast turnaround operations the effluent limitations are as set forth in the tables of s. NR 294.10, 294.11 or 294.12 as appropriate. For such operations which are fast turnaround operations, those limitations shall be increased using the appropriate factor of said tables,
NR 294.06(4)(a) (a) By addition to determine the daily maximum for either subcategory,
NR 294.06(4)(b) (b) By addition of the factor divided by 30 and multiplied by the number of turnarounds in excess of 6 in a 30 day period to determine the daily average limitation for subcategory (15) and
NR 294.06(4)(c) (c) By addition of the factor divided by 30 and multiplied by the number of turnarounds in excess of 8 in a 30 day period to determine the daily average limitation for subcategory (16).
NR 294.06 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76; correction in (1) (a) made under s. 13.92 (4) (b) 7, Stats., Register April 2018 No. 748.
NR 294.10 NR 294.10Effluent limitations, best practicable treatment. The following effluent limitations for all or specific subcategories when applied in accordance with s. NR 294.06 (3) and (4) establish, except as provided in subch. IV of ch. NR 220, the quantity or quality of pollutants or pollutant properties which may be discharged by a facility subject to the provisions of this chapter after application to process wastes of the best practicable control technology currently available.
NR 294.10(1) (1) The pH of all discharges shall be within the range of 6.0 to 9.0.
NR 294.10(2) (2) The 30-day average limitations for BOD5, suspended solids, COD, surfactants, and oil and grease are set forth in Table I in lbs/1000 lbs or kg/1000 kg of anhydrous product.
NR 294.10(3) (3) The daily maximum limitations are 3 times the daily average limitation except for subcategory (9) for which they are as set forth in parenthesis below the 30 day average limitations in table 1.
NR 294.10 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76; correction in (intro.) made under s. 13.92 (4) (b) 7, Stats., Register April 2018 No. 748.
NR 294.11 NR 294.11Effluent limitations, best available treatment. The following effluent limitations for all or specific subcategories when applied in accordance with s. NR 294.06 (3) and (4) establish the quantity or quality of pollutants or pollutant properties which may be discharged by a facility subject to the provisions of this chapter after application to process wastes of the best available technology economically achievable.
NR 294.11(1) (1) The pH of all discharges shall be within the range of 6.0 to 9.0.
NR 294.11(2) (2) The 30-day average limitations for BOD5, suspended solids, COD, surfactant, and oil and grease are set forth in Table 2 in lbs/1000 lbs or kg/1000 kg of anhydrous products.
NR 294.11(3) (3) Daily maximum limitations are 2 times the 30 day average limitations except for subcategory (9) for which they are 3 times the 30 day average.
NR 294.11 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76.
NR 294.12 NR 294.12Standards of performance. The following effluent limitations for all or specific subcategories when applied in accordance with s. NR 294.06 (3) and (4) establish the quantity or quality of pollutants or pollutant properties which may be discharged by a facility which is a new source subject to the provisions of this chapter.
NR 294.12(1) (1) The pH of all discharges shall be within the range of 6.0 to 9.0.
NR 294.12(2) (2) The 30-day average limitations for BOD5, suspended solids, COD, surfactant, and oil and grease are set forth in Table 3 in lbs/1000 lbs or kg/1000 kg of anhydrous product.
NR 294.12(3) (3) The daily maximum limitations are 2 times the 30-day average values except for subcategory (9) for which they are 3 times the 30-day average.
NR 294.12 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76.
NR 294.13 NR 294.13Pretreatment standards. The pretreatment standards for discharges to publicly owned treatment works from sources subject to the provisions of this chapter shall be as set forth in ch. NR 211.
NR 294.13 History History: Cr. Register, June, 1976, No. 246, eff. 7-1-76; r. and recr. Register, August, 1983, No. 332, eff. 9-1-83.
Loading...
Loading...
Published under s. 35.93, Stats. Updated on the first day of each month. Entire code is always current. The Register date on each page is the date the chapter was last published.