AB101: Bill Text

AB101,3,13 (b) If the injured party's percentage of total causal responsibility for the injury is greater than the percentage resulting from the defective condition of the product, the injured party may not recover from the manufacturer, distributor, seller, or any other person responsible for placing the product in the stream of commerce based on the defect in the product.

AB101,4,4 (c) If the injured party's percentage of total causal responsibility for the injury is equal to or less than the percentage resulting from the defective condition of the product, the injured party may recover but the damages recovered by the injured party shall be diminished by the percentage attributed to that injured party.

AB101,4,19 (d) If multiple defendants are alleged to be responsible for the defective condition of the product, and the injured party is not barred from recovery under par. (b), the fact finder shall determine the percentage of causal responsibility of each product defendant for the defective condition of the product. The judge shall then multiply that percentage of causal responsibility of each product defendant for the defective condition of the product by the percentage of causal responsibility for the injury to the person attributed to the defective product. The result of that multiplication is the individual product defendant's percentage of responsibility for the damages to the injured party. A product defendant whose responsibility for the damages to the injured party is 51 percent or more of the total responsibility for the damages to the injured party is jointly and severally liable for all of the damages to the injured party. The responsibility of a product defendant whose responsibility for the damages to the injured party is less than 51 percent of the total responsibility for the damages to the injured party is limited to that product defendant's percentage of responsibility for the damages to the injured party.

AB101,4,23 (e) If the injured party is not barred from recovery under par. (b), the fact that the injured party's causal responsibility for the injury is greater than an individual product defendant's responsibility for the damages to the injured party does not bar the injured party from recovering from that individual product defendant.

AB101,4,25 (f) This subsection does not apply to actions based on negligence or a breach of warranty.

AB101, s. 2 Section 2. 895.047 of the statutes is created to read:

AB101,5,5 895.047 Product liability. (1) Liability of manufacturer. In an action for damages caused by a manufactured product based on a claim of strict liability, a manufacturer is liable to a claimant if the claimant establishes all of the following by a preponderance of the evidence:

AB101,5,17 (a) That the product is defective because it contains a manufacturing defect, is defective in design, or is defective because of inadequate instructions or warnings. A product contains a manufacturing defect if the product departs from its intended design even though all possible care was exercised in the manufacture of the product. A product is defective in design if the foreseeable risks of harm posed by the product could have been reduced or avoided by the adoption of a reasonable alternative design by the manufacturer and the omission of the alternative design renders the product not reasonably safe. A product is defective because of inadequate instructions or warnings only if the foreseeable risks of harm posed by the product could have been reduced or avoided by the provision of reasonable instructions or warnings by the manufacturer and the omission of the instructions or warnings renders the product not reasonably safe.

AB101,5,19 (b) That the defective condition rendered the product unreasonably dangerous to persons or property.

AB101,5,21 (c) That the defective condition existed at the time that the product left the control of the manufacturer.

AB101,5,23 (d) That the product reached the user or consumer without substantial change in the condition in which it was sold.

AB101,5,24 (e) That the defective condition was a cause of the claimant's damages.

AB101,6,3 (2) Liability of seller or distributor. (a) A seller or distributor of a product is not liable based on a claim of strict liability to a claimant unless the manufacturer would be liable under sub. (1) and any of the following applies:

AB101,6,7 1. The claimant proves by a preponderance of the evidence that the seller or distributor has contractually assumed one of the manufacturer's duties to manufacture, design, or provide warnings or instructions with respect to the product.

AB101,6,9 2. The claimant proves by a preponderance of the evidence that neither the manufacturer nor its insurer is subject to service of process within this state.

AB101,6,11 3. A court determines that the claimant would be unable to enforce a judgment against the manufacturer or its insurer.

AB101,6,14 (b) The court shall dismiss a product seller or distributor as a defendant based on par. (a) 2. if the manufacturer or its insurer submits itself to the jurisdiction of the court in which the suit is pending.

AB101,6,20 (3) Defenses. (a) If the defendant proves by clear and convincing evidence that at the time of the injury the claimant was under the influence of any controlled substance or controlled substance analog to the extent prohibited under s. 346.63 (1) (a), or had an alcohol concentration, as defined in s. 340.01 (1v), of 0.08 or more, there shall be a rebuttable presumption that the claimant's intoxication or drug use was the cause of his or her injury.

AB101,6,24 (b) Evidence that the product, at the time of sale, complied in material respects with relevant standards, conditions, or specifications adopted or approved by a federal or state law or agency shall create a rebuttable presumption that the product is not defective.

AB101,7,4 (c) The damages for which a manufacturer, seller, or distributor would otherwise be liable shall be reduced by the percentage of causal responsibility for the claimant's harm attributable to the claimant's misuse, alteration, or modification of a product.

AB101,7,8 (d) The court shall dismiss the claimant's action under this section if the damage was caused by an inherent characteristic of the product that would be recognized by an ordinary person with ordinary knowledge common to the community that uses or consumes the product.

AB101,7,11 (e) A seller or distributor of a product is not liable to a claimant for damages if the seller or distributor receives the product in a sealed container and has no reasonable opportunity to test or inspect the product.

AB101,7,18 (4) Subsequent remedial measures. In an action for damages caused by a manufactured product based on a claim of strict liability, evidence of remedial measures taken subsequent to the sale of the product is not admissible for the purpose of showing a manufacturing defect in the product, a defect in the design of the product, or a need for a warning or instruction. This subsection does not prohibit the admission of such evidence to show a reasonable alternative design that existed at the time when the product was sold.

AB101,7,23 (5) Time limit. (a) In any action under this section, a defendant is not liable to a claimant for damages if the product alleged to have caused the damage was manufactured 15 years or more before the claim accrues, unless the manufacturer makes a specific representation that the product will last for a period of time beyond 15 years.

AB101,7,25 (b) This subsection shall not bar a claim if the claimant establishes by a preponderance of the evidence all of the following:

AB101,8,2 1. That the defective product caused a latent disease that did not manifest itself until a date on or after 3 years before the expiration of the 15-year period.

AB101,8,4 2. That the claimant commenced the action within 3 years of the date of manifestation of the latent disease.

AB101,8,6 (6) Inapplicability. This section does not apply to actions based on a claim of negligence or breach of warranty.

AB101, s. 3 Section 3. Initial applicability.

AB101,8,9 (1) This act first applies to causes of action occurring on the effective date of this subsection.

AB101,8,10 (End)