Anytime an emergency shut-off valve is replaced, the valve shall meet the requirements of subd. 1.
Tanks used to store motor fuels or kerosene shall have the water level checked and recorded at least once per month.
Anytime the water level exceeds 2 inches, the water shall be removed within 5 days.
Portable containers for the sale or purchase of a flammable or combustible liquid shall be clearly marked with the name of the product.
Liquids having a flash point of less than 100o
F may not be dispensed into a portable container or portable tank unless all of the following conditions are met:
The container or tank has a listing mark from an independent testing agency.
No kerosene, fuel oil or similar liquids having a flash point of 100o
F or more may be filled into any portable container or portable tank that is colored red.
All dispensing areas shall be provided with lighting where fueling operations are performed during hours of darkness.
Dispenser displays shall be located to be fully visible to the person fueling the vehicle.
All surface area within a 30 foot radius of the dispenser shall be maintained free of high grass, weeds and debris.
(4) Dispenser labeling.
Dispensers at facilities subject to the requirements of ch. ATCP 94
shall be labeled in accordance with the requirements of that chapter.
To be considered as being an attended fueling facility, there shall be at least 1 attendant regularly on duty on a daily basis, but not necessarily during all hours of operation, to supervise, observe and control the actual dispensing of fuel.
All point-of-sale dispensing systems, whether attended or not, shall meet the requirements in NFPA 30A section 9.5 for unattended self-service motor fuel dispensing facilities.
All new fueling facilities that are not attended as specified in par. (a)
shall have pipeline catastrophic leak detection, and sump monitors if so equipped, that will automatically shut down either the submersible pump or the dispenser operation upon detection of a system leak.
All existing fueling facilities that are not attended as specified in par. (a)
shall have pipeline catastrophic leak detection, and sump monitors if so equipped, that will do either of the following upon detection of a system leak:
ATCP 93.605 Note
Note: As an example, paragraph (c) would not apply to a convenience store and retail station that closes each day at 10:00 p.m. and then continues to operate its point-of-sale, card-reader dispensers until the store and station reopen the next day.
(6) Overfill protection.
Before delivery of product into a storage tank, the driver, operator or attendant of the tank vehicle shall measure the available capacity of the tank. The available capacity shall be more than the volume of the product to be delivered.
(7) Product transfers.
Fuel from public access fueling dispensers may only be transferred into integral vehicle and equipment fuel supply tanks, contractor pickup mounted cross-over tanks, and approved portable containers that have a capacity of 10 gallons or less.
ATCP 93.605 History
History: CR 07-029
: cr. Register November 2008 No. 635
, eff. 2-1-09; CR 09-017
: (1) (f) and (g) renum. from Comm 10.615 (5) (a) 1., 2. and (6) (b), cr. (1) (f) (title) and (g) (title) Register July 2009 No. 643
, eff. 8-1-09; correction in (1) (c), (4) made under s. 13.92 (4) (b) 7.
, Stats., Register December 2011 No. 672
; corrections in (1) (c), (4) made under s. 13.92 (4) (b) 7.
, Stats., Register October 2013 No. 694
ATCP 93.610 Fuel dispensing systems using aboveground mobile tanks. ATCP 93.610(1)(a)1.1.
Tank wagons shall be constructed and used in accordance with this subsection.
Existing tank wagons shall be brought into compliance with the requirements in par. (e)
within 5 years after February 1, 2009.
ATCP 93.610 Note
In accordance with section ATCP 93.700
, tank wagon owners and operators are required to comply with the financial responsibility requirements in subchapter VII.
(b) Duration of use.
A tank wagon may stay on the customer's premises for a maximum of 24 months.
Location and type of use.
The use of tank wagons is limited to the fueling of vehicles and equipment in the following operations:
Highway or runway construction, including associated material processing sites.
Tank wagons may not be used for fueling vehicles unless the vehicles are dedicated to the operation of the specific project or facility.
Tank wagons may not be used for general fueling of fleet vehicles or any retail sales.
(e) Specifications for tank wagons.
Tank wagons shall be constructed in accordance with all of the following:
The maximum capacity of a tank or individual compartment used to store Class I liquids shall be 330 gallons.
Tank wall thickness and joint configuration shall be in accordance with UL 142.
The fill opening for the tank shall be liquid tight, lockable and separate from any other opening.
Tanks used to dispense gasoline shall be equipped with a drop tube at the fill opening, that terminates within 6 inches of the tank bottom.
Tanks shall be provided with an updraft-type vent affixed to an 18-inch high standpipe, and the vent shall comply with one of the following:
Tanks that store Class I liquids shall be provided with a permanently mounted, listed pumping device.
A pump using a gasoline combustion engine may only be used on tanks containing Class II or III liquids.
Tank wagons shall be provided with listed fueling hose that is stored and secured on a hanger or hose reel.
Where Class I or II liquids are dispensed, means shall be provided to electrically bond the tank to the equipment being fueled.
Frames, chassis, tires, and rims shall be constructed and maintained so they are adequate to support the weight of the system and keep it stable.
Tanks with multiple compartments shall also be marked at the fill point of the tank.
Tank wagons shall be empty of liquid product while being towed off the premises where used or on any public-access road, lane or highway.
Tank wagons shall be protected from public access and public vehicle collision while on the premises where used.
Tanks placed within 25 feet of a public roadway shall be protected by collision protection.
Tank wagons that contained Class I liquids immediately before transport shall be purged of flammable vapors before transport off of the premises where used.
The fueling operator shall remain in attendance at the dispensing nozzle while fuel is flowing.
No more than 1 tank wagon may be towed at one time by a transport vehicle.
Where setbacks required in subd. 9. a.
cannot be met, the setbacks from buildings and public ways shall be the maximum allowed by the current conditions at the site, as approved by the authorized agent or the department.
This section applies to temporary uses of aboveground storage tanks constructed in accordance with NFPA 30 section 21.4.2. or a similar standard recognized by the department.
(b) Duration of use.
A movable tank may be used on the customer's property for a maximum of 24 months.
Location and type of use.
Movable tanks may be used only for fueling of vehicles and equipment in the following situations: