2017 Chapter 82

82.37 82.37  Tunnel under highway by landowner. The owner of land on both sides of a town highway may construct a tunnel under the highway, and may erect fences that are necessary for the use of the tunnel. The tunnel shall not interfere with or endanger travel on the highway. The owner shall maintain the tunnel and shall be liable for all damages that occur as a result of the failure to keep the tunnel in repair. Unless authorized by a town meeting, the tunnel shall not be less than 25 feet in length. The electors of the town at an annual town meeting may authorize the construction of a tunnel that is less than 25 feet, but at least 16 feet in length.

82.37 History History: 1989 a. 56, 359; 2003 a. 214 s. 138; Stats. 2003 s. 82.37.

82.37 Note NOTE: 2003 Wis. Act 214, which affected this section, contains extensive explanatory notes.

82.50 82.50  Town road standards.

82.50(1) (1)  The following minimum geometric design standards are established for improvements on town roads: - See PDF for table

82.50(1)(a) (a) Local service, intermittent traffic

82.50(1)(a)1. 1. Right-of-way   3 rods

82.50(1)(a)2. 2. Roadway width   20 feet

82.50(1)(a)3. 3. Surface width   16 feet

82.50(1)(b) (b) Under 100 ADT

82.50(1)(b)1. 1. Right-of-way   3 rods

82.50(1)(b)2. 2. Roadway width   24 feet

82.50(1)(b)3. 3. Surface width   18 feet

82.50(1)(b)4. 4. Maximum grades   9 percent-11 percent

82.50(1)(c) (c) 100 to 250 ADT

82.50(1)(c)1. 1. Right-of-way   4 rods

82.50(1)(c)2. 2. Roadway width   26 feet

82.50(1)(c)3. 3. Surface width   20 feet

82.50(1)(c)4. 4. Maximum grades   8 percent-11 percent

82.50(1)(d) (d) 251 to 400 ADT

82.50(1)(d)1. 1. Right-of-way   4 rods

82.50(1)(d)2. 2. Roadway width   32 feet

82.50(1)(d)3. 3. Surface width   22 feet

82.50(1)(d)4. 4. Maximum grades   6 percent-8 percent

82.50(1)(d)5. 5. Curvature   6°-12.5°

82.50(1)(e) (e) 401 to 1,000 ADT

82.50(1)(e)1. 1. Right-of-way   4 rods

82.50(1)(e)2. 2. Roadway width   34 feet

82.50(1)(e)3. 3. Surface width   22 feet

82.50(1)(e)4. 4. Maximum grades   5 percent-8 percent

82.50(1)(e)5. 5. Curvature   5 °-12.5°

82.50(1)(f) (f) 1,001 to 2,400 ADT

82.50(1)(f)1. 1. Right-of-way   4 rods

82.50(1)(f)2. 2. Roadway width   44 feet

82.50(1)(f)3. 3. Surface width   24 feet

82.50(1)(f)4. 4. Maximum grades   5 percent-7 percent

82.50(1)(f)5. 5. Curvature   4.5°-7.5°

82.50(1)(g) (g) Over 2,400     State trunk standards

82.50(2) (2) The department may approve deviations from the minimum standards in special cases where the strict application of the standards is impractical and where such deviation is not contrary to the public interest and safety and the intent of this section.

82.50(3) (3) This section does not apply to improvements on town roads existing on October 1, 1992.

82.50 History History: 1981 c. 20; 1987 a. 137 s. 6; 1989 a. 56; 1991 a. 39; 1993 a. 490; 1999 a. 85; 2003 a. 214 s. 182; Stats. 2003 s. 82.50.

82.50 Note NOTE: 2003 Wis. Act 214, which affected this section, contains extensive explanatory notes.

82.51 82.51  Rules for town road bridge standards. The department shall establish by rule uniform minimum design standards for the improvement of town road bridges.

82.51 History History: 1981 c. 20; 1987 a. 137 s. 6; 2003 a. 214 s. 83; Stats. 2003 s. 82.51.

82.51 Note NOTE: 2003 Wis. Act 214, which affected this section, contains extensive explanatory notes.

82.52 82.52  Rules for town road standards. The department shall establish by rule uniform minimum geometric standards for the improvement of existing town roads.

82.52 History History: 1991 a. 39; 2003 a. 214 s. 184; Stats. 2003 s. 82.52.

82.52 Note NOTE: 2003 Wis. Act 214, which affected this section, contains extensive explanatory notes.